- Fixed some small issues when testing prospector script
- Navigation mode will no longer try to align the drone to the target alignment vector when travelling to job site

- Implemented delay after docking end point reached before resetting AI docking module, incase of docking failure.

This is a workaround to a delayed connector status update and less than perfect precision with AI block navigation

- Fixed bug with thruster group tag arrangement.

Thruster group label example as follows:

"Thruster [SWRM_D 1]"

- Fixed bug with thruster group tag arrangement.

Thruster group label example as follows:

"Thruster [SWRM_D 1]"

- fixed bug for mining location

- Fixed an issue where new waypoint locations were being added and not cleared when remote control fails to detect world position correctly. As a safety measure, waypoints are always cleared before adding, removing the assumption that a waypoint is always correctly reached via remote control.

- Should resolve issue with exit shaft flight path on planets

- Drones now use terrain clearing mode when drilling the ignore depth section of the bore hole.

Note: Take care when using this setting, as there is no way to detect ore when in terrain clearing mode. I recommend you leave at least 5 - 10m before the ore to avoid clearing ore. Alternatively, set ignore distance to zero to pull all materials as per normal drilling.

- Added optmisations around command handling of AI task recorder and move blocks
- AI blocks should now be fully disabled when idle - reducing sim load when not in use, these would not stop as expected previously.

- Added low gas tank to recharge request when hydrogen tanks are not ignored

- Added recharge request trigger on low battery
- Added undock request cancel if low battery charge