Cannot drive with Logitech G293

[virqz]

Hi everyone,
I just got a new Logitech G293 and wanted to play ETS2 with it, I already configurated controls and gears etc, that all works. But, if I actually try to drive the truck, it wont move. However, the motor does rev up and the gears all work (I was in 1st). I also do not have the break active.

Help would be greatly appreciated!

[ED-2142]

By default, my pedal borad , when I reset the mapping of my axis , the accelerator is instead of the brake , the brake instead of the clutch , and the clutch instead of the accelerator . Finally something like this .
So i remap the pedales with the good axis .
Be sure that the accelerator axis is well mapped with the accelerator pedal, the brake axis with the brake pedal, and the clutch axis with the clutch pedal.

also look at their curves, if they are standard, inverted, or centered

Because your problem looks like this, and if you shift into gear without stalling or the gearbox doesn't squeak like a jackhammer, it's the clutch that's reversed.

[Elton_Belton]

im also having a problem but thats with my g29 i was plugging in it to my computer one day to play euro truck simulator 2 it doesent want to show up as a device in the game because thats weird because its been working evry day until now

[ED-2142]

Originally posted by PrivateElton:

im also having a problem but thats with my g29 i was plugging in it to my computer one day to play euro truck simulator 2 it doesent want to show up as a device in the game because thats weird because its been working evry day until now

Look in Ghub how your G29 behaves.
Also consider going back through the in-game controller assistant.
And also check your controller settings in steam imput, if there is not a conflict.

[virqz]

Originally posted by ED-2142:

By default, my pedal borad , when I reset the mapping of my axis , the accelerator is instead of the brake , the brake instead of the clutch , and the clutch instead of the accelerator . Finally something like this .
So i remap the pedales with the good axis .
Be sure that the accelerator axis is well mapped with the accelerator pedal, the brake axis with the brake pedal, and the clutch axis with the clutch pedal.

also look at their curves, if they are standard, inverted, or centered

Because your problem looks like this, and if you shift into gear without stalling or the gearbox doesn't squeak like a jackhammer, it's the clutch that's reversed.

Good idea, sadly not correct in my case. The clutch, brake and acceleration pedals are all correctly mapped. The break and gas are put in as "reversed" and the clutch as "normal", because my motor dies instantly if the clutch is put in as "reversed".

[virqz]

Also interesting: if I have the steering wheel plugged in, I cannot drive even with m&kb

[ED-2142]

My g920 clutch is set in reversed , 0% deadzone , and 75% slip point .
On the other hand, I have to re-open and clean (again) my accelerator potentiometer, which is a little crazy when fully pressed. About once a month... It's boring... Can't wait for me to switch to a Thrustmaster steering wheel with magnetic pedalboard .

Edit:
It just made me tilt. Do you use realistic air pressure ?