Aactual G scale Stuff

The G.M.G.M.R.R.C. is a small group consisting of players of gmod trainbuild that are interested in modeling whats for not the best relisation of G scale model railroading in Garry's Mod. To become a member of the club you need to be able to build yourself a "Gscale locomotive or car" IF not then i have cars and locomotives you can aquire. When referd to as "Gscale" you might think about SligWolf tracks but that is very much over scaled to be considerd "Gscale". To lay "Gscale" tracks you will need any 6tall and wide X andy length of "SPROP" plate and each pice of rail should be seperated by the width of the rail itself to allow the "PIN" wich is a referd cilinder that is a yellow (cylinder5x6) to be able to fit between the rails themselves with atleast 3 fourths the width of the pin in every spot to guide the locomotive or car through the layout in question. Placing the rails should be easy where as stated before you need two (6wide and tall times X length SPROP plates). When laying track there should A width of the rail itself between the "rails". The rails should be pushed down twice at the setting of "1" with the tool (percision alignment). Under the rails should be a flat pice of flat prop that should have collisions enabled so that the "PIN" can slide and guide the >locomotive & or car< along the rails and keep the pice of rolling stock level with the rails. When building a train a "BASE" for a (40foot BOXCAR) should be at the least a (rect_12x24x3) and have any "truck or guiding system" that can support and keep the freightcar on the tracks without major derailment or diesasterfey. When making a locomotive (steam) it can be iffy but the width should be a safe (12 wide SPROP pice or any width that can be made for sereal running of trains or the ENJOYMENT of the person running the train. If your train derails you might need to mess around with the base & pin on the locomotive or cars. When connecting trains "Rigid Rope", "Magic Crowbar E2>if not outdated<" and almost any other train connecting E2 that is Safe for Running of trains and :SHOULD: be connectin by either the "PIN" of the car, locomotive or other train hence having a working train.

( this was a WIP guide to trains in "Gscale" for GMOD via - 8/21/2016 )