Glitch building

[Scorpion]

I have made small size base to base teleporters in the past but now using the wire technique it always lays on its side. I can rotate in one direction but not both, (the wires aren't twisted) Any ideas?

[Zigamus Wizard]

Beeblebum is the glitch builder, check his vids on YT

[Barmy Nimrod]

When Glitch building short range teleporter bridges, I place a wire on the floor of the panel, center to one edge. I wire glitch the first teleporter in the center, then add a new wire from the center wire connector to the opposite edge. Delete the first wire, then wire glitch the second teleporter. They should be facing opposite directions, perpendicular to the floor panel. I typically do all my glitch building in camera mode. I have not had issues with orientation since planets 1. I will have to see if Planets II did something.

[Scorpion]

Thanks for the reply but I am talking about the long range not the short range.

Originally posted by Zigamus Wizard:

Beeblebum is the glitch builder, check his vids on YT

I was following his videos that is where I learned how to do it to start with.

[Shadow Strider]

Originally posted by Scorpion:

Thanks for the reply but I am talking about the long range not the short range.

Originally posted by Zigamus Wizard:

Beeblebum is the glitch builder, check his vids on YT

I was following his videos that is where I learned how to do it to start with.

Are you using a scaled down wire for scaling the teleporter?
If so, did you lay the wire on the floor or a wall? You want it on the floor.
Afaik, if you put the wire on a wall, then that wire will be on it's side, and when you copy it for the scaling glitch, you copy the orientation to...