No Man's Sky

No Man's Sky

View Stats:
Snakewood Jul 24, 2018 @ 11:30pm
Cannot break into reinforced doors on manufacturing
Anyone else have this trouble?
< >
Showing 1-8 of 8 comments
Nerivant Jul 24, 2018 @ 11:31pm 
Need explosives or your ship for it now, I just did a strafing run with my starter ship and blasted them open.
Snakewood Jul 25, 2018 @ 3:24am 
hi, thanks for reply, i installed boltcaster and it went fine. Not sure why the laser isn't doing it anymore, not even slowly.
Soulless Jul 25, 2018 @ 3:29am 
use grenades and make sure you stand back a bit from it or you'll blow yourself up.
Man_In_Suitcase Jul 25, 2018 @ 3:32am 
Ships work nicely, then lay low till the sentinals wanted level drops and done.
Agronox Aug 23, 2018 @ 9:12pm 
Originally posted by Man_In_Suitcase:
Ships work nicely, then lay low till the sentinals wanted level drops and done.
I find it saves time if you just break the door with your ship, land then enter the facility. By the time you are done in there the sentinels have lost you.
MS. Green Label Aug 23, 2018 @ 10:10pm 
Originally posted by Snakewood:
hi, thanks for reply, i installed boltcaster and it went fine. Not sure why the laser isn't doing it anymore, not even slowly.
just don't install a s-class module update for the boltcaster, it uses ricochet and bounces off the doors
Originally posted by CSD - Dark:
Originally posted by Snakewood:
hi, thanks for reply, i installed boltcaster and it went fine. Not sure why the laser isn't doing it anymore, not even slowly.
just don't install a s-class module update for the boltcaster, it uses ricochet and bounces off the doors


you can have 3 S class modules for the boltcaster without having the ricochet mode enabled. it's always random if the mode will activate or not
Bubba Fett Aug 23, 2018 @ 11:08pm 
Why would they even have a ricochet mode on the boltcaster? It's not like bouncing a bolt off a wall to shoot something in the back is going to do more damage to it.
< >
Showing 1-8 of 8 comments
Per page: 1530 50

Date Posted: Jul 24, 2018 @ 11:30pm
Posts: 8