Store Page
ARK: Survival Evolved
All Discussions Screenshots Artwork Broadcasts Videos Workshop News Guides Reviews

ARK: Survival Evolved

Store Page
ARK: Survival Evolved >  Workshop > ExileAcid's Workshop > Castles, Keeps, and Forts (Legacy) For new version go to Castles Keeps and Forts Remastered. This version still works > Discussions
Castles, Keeps, and Forts (Legacy) For new version go to Castles Keeps and Forts Remastered. This version still works
Description Discussions299 Comments4660 Change Notes
restles5nativ3 May 10, 2017 @ 10:49am
Windmill
Love the mod. Cant get the Windmill driveshafts to snap to the Windmill itself and the Millstone wont snap/place to the foundations or ceilings. Didnt use it before the update (257) and I am on the Island.
< >
Showing 1-6 of 6 comments
eNc | Henrik May 10, 2017 @ 3:16pm 
Use the four way driveshaft from the windmill and then continue from there. The top of the millstone will snap to a driveshaft when it has connection with a foundation or ceiling.
#1
restles5nativ3 May 10, 2017 @ 4:39pm 
ok, I did notice it was the only one to connect but it sticks out through the wall so wasnt sure if that was right or not. thanks for the reply
#2
Snicker May 17, 2017 @ 5:13pm 
Yeah, I think there's a problem with the snap point and angle for the junction. The junction snaps at 45 degrees off from where it should to be "in line" with the main drive shaft of the windmill, and it's about half a foundation to close to the windmill as well - if you run a series of vertical shafts downwards from the default junction, it ends up with the mill halfway through a wall.
#3
johnathon007 Feb 21, 2018 @ 2:41pm 
Why has this still not been fixed?
#4
Snicker Feb 21, 2018 @ 3:55pm 
CKF was abandoned last year.
#5
johnathon007 Feb 21, 2018 @ 4:42pm 
Originally posted by Snicker:
CKF was abandoned last year.
Oh that explains everything.
#6
< >
Showing 1-6 of 6 comments
Per page: 1530 50