@queazykilla. It works perfectly fine, took it for a test right after reading your comment, make sure to follow the start up procedure and that inf fuel and electric are both turned off.

So its not working anymore-

@Daclundunk, I like your idea, sounds useful I might add that, thank you for the feedback :D

or something to make it so it can be recovered at 0% battery

can you add cable to engine bay to be able to jumpstart it?

@PorygonTheGreat, I've been testing the plane with a friend for about an hour now, I cannot find the issue that you mention. Could you please send a clip of you starting the plane to where you find the issue. DM me @"bunbunballer" on Discord.

I've messed with this thing for 3 hours and followed the start-up procedure every time, the RPS drops every time you slam the pitch to take off and it ends up rolling at taxi speed the length of the runway. U-turn, turn pitch back down, RPS increases to full again and slam the pitch, RPS drops again and roll to the other end. What am I doing wrong?

Every single time i go to fly it, i get it in the air and then less than a minute and a half later, it just stops, the engine just stops, even if i am going a bit down, just stops and then it falls out of the sky, pls fix.

@Scotsman. Follow the start up procedure, taxi to the runway, let the engine hit full RPS, then slam your prop pitch. This aircraft is very realistic, it's large and has a weak engine, you have to be careful with how much lift you give it as too much will lead to a stall.

It just wants to be a car I took off and immediately it starts losing altitude then hits the ground then just drives along it is stupid I don't know what I did wrong.

cute

nice plane

cooles Plane

W

@Neotastic. If what you are asking is if you can make a livery for my plane then the answer is yes, HOWEVER you can NEVER post the plane to the workshop, you are allowed to keep the modded version of the plane for yourself to enjoy but this is still my creation at the end of the day.

can i make a Antonov an-2 [US Livery]

@Neotastic, I will most likely not make more livery's for the Antonov An-2, if you keep posting the same comments I will start removing them.

Can you make Antonov an-2 [US Livery]
pis do it

@rotanev, for some of my screenshots I used the Opal shader, you can find it online.

How do you make the water look so cool?

this is so slow you mention a STOL feature which doesn't work for me, I did the start up properly and tried every pitch level... it is slow.

@♡BUN BUN♡, Incredible. That was fast! Keep up the great work, sorry for bugging you about it!

@Nitty_Gritty1, I'm gonna say this right now so you and everyone knows, a float plane version of this plane is on the way!

Whew, seems like this popular creation has a lot of requests. Before adding to your enormous pile of requests, I just wanted to tell you what a fantastic creation you have made. Truly amazing craftsmanship. Being created in a game covered in mostly water, this vehicle does have one downside, it's inability to land in water more than once :-). On this note, how difficult would it be to convert it into an An-4? Or maybe a version with skis? Again, I apologize for adding yet more requests to your basket, I am sure you are already quite busy. Good luck, and take care!

@Neotastic, I could consider it, wouldn't be too hard, however I can't promise anything.

@frugt19. Please read the instructions listed above carefully and do the procedure, you may have missed a step.

bruh i cant get i to kove and i did everything in start is there somthing more i needa press or start or smth pls tell me

or [Canadian Livery] Antonov an-3

can you make Antonov-225 [Canadian Livery] pis if not it ok!

@ieatdonutsfordinnerrr Maybe would if I could find some info on it.

@haiyolo, Hi you're not the first to mention this, what I recommend you do is allowing the engine to hit max RPM and having throttle to full before you set your prop pitch.

is anyone finding that when you start to increase prop pitch the engine can't handle the load and then the rps drops? anyone got tips on setting the prop pitch to sort out takeoff

Can You Make A Version Where Its A Flying House?

@ldoyen12, Are you sure you set throttle to full? if it isn't full chances are it didn't have enough power to lift.

I did everything correct taxied to the runway then as soon as a launched the plane it slowed down and the engine stopped did i do anything wrong?

@Dogman86, That's not a bad idea, might do it.

Do you think that you could make a seaplane variant I think it would be cool in a game so water related

Finally Андва)

jesus christ that jumpscared me. (yeah im not sure why either) it worked, dayum. Maybe that was common sense, heh.

Well, let's see...

it worked thanks

@mrb0503, @crod523, Make sure you've subscribed to the plane, then close stormworks, and reopen it, that might work.

im having a problem similar to mrb0503: I subscribe to a vehicle, but when i go to addon editor and go to "load", then "steam workshop" ITS NEVER FOCKING THERE. I don't understand why it's happening, nobody else seems to be having the same problem, so maybe im a complete dumb ahh.

so i'm trying to subscribe and play with it but it isn't in the game even when i reload. what do i do

Having spent time in the real thing recently, I have to say that this is amazing. The only thing that I would change is having an artificial horizon and more gauges in front of the pilot.

mother fockin epic

@RedRobot, I got it from blenderkit, but it's just a winter sky dome, the hangar is a prop.

Where did you get the HDRI background for your thumbnail?

Build is awesome, but this is not "realistic" in any way. Dimensions are closer to an12 than an2.
Still awesome build tho, if you forget that it is meant to be an2.

the work in general is very cool, and it's nice to manage, but if we talk about the size of 1:1, then your An-2 is very large (2 meters each), as well as the side windows are made a little differently