how do u make it go over 20 mph

When deploying the minisub with the crane i used both cranes and the weight of it sunk the ship

very good

@why are some doors locked? which? Only the armory should be locked!

why are some doors locked?

@Delusional_Idiot Thanks for letting me know, it was my error for uploading that incorrectly. It is fixed now :)

when i try to load it i just get an R.S.V. Alaska

@Convict666
421403

whats the armory code?

The fix is now live - It should not be lifting in high winds anymore!

@Davo I will have to color the removed wing blocks (my test was very vulgar looking) and then I will upload the fixed vessel :) Thanks for letting me know again

@Davo I did some tests and it is the wing sections causing this issue - I created a version where I removed the wing sections, and while the vessel sits a little lower in the water, the speed is not much affected, but when the wind is turned up to the end, the ship does not lift out of the water and start to fly hahaha Granted, the ship is still top heavy, and inevitably will want to roll in high winds, but there are the methods mentioned below that can reduce rolling

@Model Guy Thanks for the comment! I think the fuel reserve is large enough to play in realism mode, and I have tested that on several occasions. The top speed is not meant for long sustained travel, and using the right gears and throttle combos will let you travel quite far:)

it might be worth putting in the description that it need infinate fuel

@gold_on_crack and @bot_imppa
421403

CODE PLS

what the armory code

@Davo Thank you for all your patience and explanations :) Glad you like it!

@454SS Thanks for looking into it, outside of it taking off, amazing vessel.

@Davo I will do what I have to in order to correct this issue

@Davo Thanks for looking into this and for your comment :) I will look into this... I suspect it has to do with me using the wing section for the decks and wall to save on the weight. I guess adding these sections wants to give the vessel lift oops

something is just really wrong with this vessel, i added so much ballast the rear went under water, the wind lift the boat out of the water and it flew like a bird. So the weight did nothing.

99% of the other boats do not do this, something is very off with this vessel.

@454SS yea i tried the ballast, it did not seem to make a difference. Basically when the artic winds kick up its over for the vessel, instantly flips it with no time to change direction.

Is it possible to add more weight to the bottom, or more ballast?

@Davo thanks for the comment! Please note that this is a luxury yacht and not a SAR boat. The following quote is from the description: "The Vai can withstand the forces of the open sea, however, at the expertise of the captain". Try to enable the ballast to lower the ship into the water, you can also set the pitch to make the ship lower in the water, and also lower your speed in general. Try to also steer with the wind, not perpendicular to it. Please also refer to the Notes section above.

the ship takes off like a kit in strong wings, or rolls over.

Thanks!

@Origin I have also added a note in the ROV station explaining this :)

@Origin Into the huge winch

Where does the ROV connect?

@RyderDe317 Thanks for bringing that to my attention! The ballast tank was working, but the dial and indicator were not, but it is fixed now! :)

@Adri4n Thank you!

THE port ballast tank is never operational

nice boat

thanks,
I just found that now

@rockinf1234567 Thanks for the comment! There is a note in the bridge, but it is 421403

What is the armorycode

@elhsgiuloigtn Thank you! :)

@sovietmusiclover Thank you! Enjoy!

this is pretty cool

nice boat