how about making the griffon perhaps

pls add stationary depth hold

but how do we get the small sub

nice 10/10

thanks !

love your submarine's

how do i dive?

This thing is awesome! Works well

An engine dies some time after it submerges into water. Plus it doesn't want to start up while under the water line

There's an airlock on top

how do i exit the vehicle while under water

RIPnDip yes it is an advanced submarine

Fuzzy, buoy tender is not yet in my creation list however one of the two ships I'm working on right now could be used to drop buoys even if it's not its main role.

is this an advanced ship or no?

Can you build another buoy tender?

Svenska!

Thank you.

Thanks for your changes! :D

Dear FluffyPony and Dear Misha. I have paid attention to your reviews and the sub has been updated I have added a button to display the sonar on one of the front screens, added an override for the 2 vertical propellers, fixed the diving bell button, and changed to a toggle ballast discharge button, I have also added the controls that were not listed. Thanks for your reviews !

Misha, the clutch does work its just not sticky, you have to hold w or s to go forward or backward with the seat or above your head in the pilot seat there is a lever clutch

The legend is back

The controls aren't fully listed in the pilot seat and the clutch control for the seat doesn't work. I also wish there was a depth hold and standard autopilot. The map thing is cool and all, but it's a pain to navigate with. Otherwise, a nice sub.

Thank you for these suggestions for improvement. I'll see what I can do tomorrow.

3. add override ability for the 2 vertical propellers in the front (can lift the nose and make you go upwards even with full ballast tanks!)

4. replace the velocity pivot fot the sonar monitor with a normal pivot (does not move around that much

5. add a digital display for the height above ground for the pilots (it sucks to run back to the sonar to get this information)

Dear createor :D

It is a very nice submarine, but i have some ideas for improvements and some nasty bugs.

1. The two toggle buttons for the diving bell are connected in a circuit, sometimes they will just endlessly toggle themselves (not good). Please use two push buttons and a push-to-toggle-logic-component.

2. change the behaviour of the "clear ballast tank" to toggle, same with the down and up lights

Thanks for the workshop upload!

Hey dude that is an amazingly accurate, good job and keep up the good work

noice

Nice :)

BEAUTIFUL JOB! I'm a sucker for a good Submersible!