Subscribe to download
VRE MPI MXpress

This is a semi-1:1 recreation of the MPI MPXpress, which due to the few small changes I made, I dubbed the MPI MXpress. The train itself is a Disel-Electric locomotive, used by many commuter railways around the world. The one that this specific locomotive serves for, the VRE (Virginia Railway Express) is a commuter railway that serves the Virginia side of the Washington DC metro area.

Real statistics:
Produced: 2003 - Present
Amount produced: 217
Length: 20.75 m
Width: 3.2 m
Height: 4.7 m
Total Locomotive Weight: Between 129,000 and 134,000 kg
Maximum Speed: 132-165 km/h (depending on gearing)
Tractive effort: between 322,000 and 380,000 N

In game statistics:
Powerplant: 4 large diesel motors, each powering 1 large generator, with 2 large electric motors onboard.
Electrical generation: 2,500
Endurance (Max throttle): ~40 minutes (~80km)
Endurance (Efficient throttle): ~4.5 houts (~400km)
Max speed: 110 km/h
Fuel stored onboard: 42,000 diesel, with capabilities to refuel
MU (Multiple Unit) capabilites: "plug and play", uses composite over electrical cables

How to start:
Step 0.5 (Only applies if you are running more than one locomotive) - Get out, and check the front and back couplers, and make sure the RED data cable is plugged in through all locomotives you want to control. As long as each locomotive is connected to each other, they will work fine with only this setup. MAKE SURE that the ONLY train with the "Train is master" button turned on is the one you would like to control from.
Step 0.75 (Only applies if you are using the Gallery IV cars) - Get out, and check the front and back couplers to ensure that the YELLOW power cable is plugged in to the cars. This cable should also be connected through any other locomotives used in the train.
Step 1 - Get in the cab of the locomotive you would like to control the consist from.
Step 2 - Press the "Train is Master" button, located central on the console.
Step 3 - Turn the "Engines on" key to the on position. The locomotives diesel engines should turn on, and if you are running multiple engines they all should now be idling.
Step 3 - Ensure you are ready for departure, and when so, turn up the throttle.

Tips for use:
If you are using only locomotives / only one locomotive, there is no need to raise the throttle above 0.2, as the train reaches its max speed fine without.
Some wheel slip while starting is normal, especially if you put the throttle to maximum. Do not worry, the anti-wheelslip system will take effect momentarily.
Most of the trains systems will not work unless the "Train is Master" button is toggled.
The train works in any direction relative to the control train, there is no need to reverse the locomotive or anything. It also works as a pusher loco for the cab car that I have built.

CAB CAR: https://steamcommunity.com/sharedfiles/filedetails/?id=2651202819

REGULAR PASSENGER CAR: https://steamcommunity.com/sharedfiles/filedetails/?id=2651202123

While this should be implied, please do not copy.