Subscribe to download
[FIXED] Sherline DXR-1 Support Ship

After 2 month's of building, testing, decorating and crashing I am proud to present to you the DXR-1!
Before I get into how you turn this bad boy on I'd like to mention some special people.

Edit: Now with the new updates I've finally fixed the lazy wobbling AND it TAKES OFF! :) So now you can explore the skies once again, however since Jet Turbines guzzle you might just barely be able to make it to the artic if you use as minimal amount of throttle as possible. :o

The DXR-1 is based off the sketch by Orpheus7
https://www.deviantart.com/orpheus7/art/Combat-Pack-Ship-41312303

• Krail for teaching me how to create Jet Turbine VTOL Logic.
  
• Ghost for helping me in general with creating the DXR-1 and being my prime competitor in making a cooler spaceship than his.
  
• Woodspeople for helping me with the EDF-1 hover logic.
  
• Edvin (aka AESD) for helping me with the finicky strobe light affects for the EDF-1 and DXR-1.
  
• Daylight4449 for designing and constructing the EDF-1 hull.
  
  
  Discord
  For interacting with new comers to the game and old players I've created the Sherline discord to create and discuss building complicated space related vehicles and for general help all together!
  This is a relatively new discord so all new members are welcome.
  
  Sherline Discord: https://discord.gg/mBYEXA9
  
  Don't forget to
  
  
  
  Features
  
  
• GPS Autopilot (Provided by Taijin)
  
• Altitude Autopilot
  
• A stand and walkway for easy access
  
• EDF-1 Deployable for rescue/recovery missions
  
• 2 1/2 Hours of fuel.
  
• Warning light up board to indicate a problem with any engine on the DXR-1
  
• Emergancy Chutes for the DXR-1
  
• Emergancy Chute for the EDF-1
  
• 2x High output Generators
  
• 140,000 litres of jet fuel
  
  
  Startup Procedure
  
  1. Open the fuel valve and turn on all pumps (Located on the front board above the seats)
  
  2. Between the two pilot seats turn on the VTOL Microprocessor and Gyro
  
  3. Turn on the Left Rear Lift Engines, Right Rear Lift Engines and Front Lift Engines with their corresponding keys just above the fuel control panels.
  
  4. Push the lift throttle to 120.00 and press the Up Arrow key on your keyboard to begin rising.
  
  5. Rise to an altitude of 50 metres then with the corresponding key turn on the Rear Forward Thrust engines.
  
  6. Push the Forward Thrust throttle to 100.00 to begin moving but do it slowly, because you'll nose dive if your not careful.
  
  Tip: If the craft is rising too much on its own at high speeds (around 180 knots to 220 knots) increase the trim and vice versa.