Fallout 4

Fallout 4

View Stats:
Relay Towers/Dishes and Signals. Someone figure these out yet?
So I am rather curious, because this is confusing as hell for me.

The Relay towers, once activated, will provide a couple of signals with looping messages. I know these signals have to be 'found' by tuning to the stations, and then walking in a direction until it's clear enough to listen to.

Are these actually meant to lead somewhere? Is there a way to pinpoint where the signal is actually broadcast from as well?

I'm just curious about this, and found very little info in the regard! Any help would be appreciated.
< >
Showing 1-5 of 5 comments
Jedi Nov 12, 2015 @ 9:51pm 
to the left there's a reading which gives you a Signal strength %. Just follow the beeping and the %.
garravesh Nov 12, 2015 @ 9:53pm 
Every few seconds the beep will be accompanied by a PERCENTAGE...also as you get closer it becomes more pronounced. Thus assumes you put the source on your radio and listen ot it.
I don't seem to have that feature o.O Am I meant to go a bit further along a story-arch? I tend to just run around in FO games, not doing the story till I explore a large amount of the map
Jedi Nov 12, 2015 @ 9:59pm 
Originally posted by F-7 Mister Naga:
I don't seem to have that feature o.O Am I meant to go a bit further along a story-arch? I tend to just run around in FO games, not doing the story till I explore a large amount of the map

Open your pipboy, switch to the appropritate radio station; follow the blips.
It's not story related...well some of them are.
I dunno, the radio stations do not show any tracking/percentage. The only time I've seen the %Signal Strength, was during mission-related ones, not from Radio Towers.
< >
Showing 1-5 of 5 comments
Per page: 1530 50

Date Posted: Nov 12, 2015 @ 9:49pm
Posts: 5