A faster way to tune cars for BeamNG?

[RiftHunter4]

Is there a faster way to tune cars for BeamNG? Automation takes a good bit to load up and I'd rather not have to spend 3 full minutes just to adjust the camber by a couple of points and then have to export again.

For one or two changes it's ok, but when you need to do a lot of work on a car, it gets to be time consuming, sometimes taking hours just because you end up waiting so much.

[Killrob]

I think if your machine is strong enough you can run both games at the same time, and just re-exporting and then pressing respawn in Beam hotloads the car changes. Not entirely sure that works, but I think I remember it being possible like that.

[RiftHunter4]

Origineel geplaatst door Killrob:

I think if your machine is strong enough you can run both games at the same time, and just re-exporting and then pressing respawn in Beam hotloads the car changes. Not entirely sure that works, but I think I remember it being possible like that.

I'll give it a try.

[Arya]

That does work, and a modern desktop *should* be able to handle both games without too much trouble. I've been able to run both quite comfortably - turning down Automation's settings helps a lot. Since you're only using the UI, you're not really gaining anything from graphics.

[RiftHunter4]

I tried running both at the same time and it works really well. BeamNG automatically updates the car when it's exported so you don't even need to start a new session or time trial.