Stormworks: Build and Rescue

Stormworks: Build and Rescue

Ikke nok vurderinger
ff-x7 core fighter
   
Utmerkelse
Favoritt
Favoritter
Fjern som favoritt
Merkelapper: v1.0.28
Filstørrelse
Lagt ut
Oppdatert
521.795 KB
22. des. 2020 kl. 23.52
18. jan. 2021 kl. 2.31
10 endringslogger ( vis )

Abonner for å laste ned
ff-x7 core fighter

Beskrivelse
Core booster unit : https://steamcommunity.com/sharedfiles/filedetails/?id=2362354738

explanation of input
--seat data
[a]/[d] aileron, steer of landing gear
[w]/[s] elevator
[w] wheel variable brake
[right]/[left] rudder
[up]/[down] throttle (You can see throttle level at vertical gauge in upper right monitor.)
[1] attenuate input to wing
[3] use chosen equipment (You can see equipment at lower left monitor.)
[4] fold landing gear
[5] activate flap
[6] transform to docking mode

--front switches
--Center panel is flight assist. When these functions are available, they will highlighted in upper monitors with green number.
[roll correction] keep horizontal.
[keep altitude] You can increase or decrease the set point by [w]/[s] while this funcion is active. You can see the set point at upper left monitor.
[keep direction] Keep the last direction when you stop pushing [left] or [right] key.
--Left panel is equipment list. You can see the equipment in lower left monitor.
[prev equip]/[next equip] Switch equipment.
[safety] Release safety and you can use the equipment by puching [3] key.

--right switches
--upper
[canopy] Open or close canopy.
[power] Turn on the monitors and keep engines active.
[navigation light] Turn on the navigation lights.
[start engine] Activate compressors and assist motors.
--lower
[master mode] Activate if you combine the core booster or somthing.
[booster VTOL] Activate VTOL mode of core booster if you combine it.

--left switches
--upper
[taxing light] Turn on the taxing light.
[release wheel] Release wheel brake and thrust spoil.
[fold wing] Fold wing to combine core booster.
[release connectors] Release all connectors of core fighter.
--lower
These functions are for core booster then nothing will happen if you switch without core booster.
[activate cargo connector]
[activate tank connector]
[guide laser]

operations
You can start engine by switching [power] and push [start engine] once.
If you push the [start engine] once, engines will automatically start and keep more than 1 rps.
You have to switch [release wheel] or the core fighter will never launch.
When thrust power reaches certain level, it will launch and you can takeoff!!
If you want to stop engines, switch off [power] and they will stop until you push [start engine] again.
7 kommentarer
WANDR Productions 20. sep. 2021 kl. 4.13 
THIS IS THE BEST
unippu  [skaper] 16. jan. 2021 kl. 8.52 
I'm sorry but docking mode is just a transforming function.
But I'd like to make the rx78 gundam or something if I can with this core fighter!!
puppy 15. jan. 2021 kl. 19.57 
yes
SlicedBread28 15. jan. 2021 kl. 14.54 
what does docking mode do?
■ Endless Suffering ■ 31. des. 2020 kl. 23.14 
the FF-X7 core fighter for the RX-78-2 Gundam from Mobile Suit Gundam, it’s basically the central module for the pilot to pilot the fighter or the gundam.
kak the protogen 31. des. 2020 kl. 10.05 
?
■ Endless Suffering ■ 27. des. 2020 kl. 19.31 
someone actually did it omg