Sorry but what a load of rubbish just afte rleaving you get a note you are taking a siding at mitcheal but there is absolutely no indication as to where mitcheal is unntil you get a notice faiuled account have not slowed to Stop AT MITCHEAL YET I HAD REUCED FROMTRACK SPEED

A nice little scenario that I enjoyed running. Everything went fine, the scenario completed properly, but I did not get the completion check in the Standard scenario list. Ran it again, just to make sure, and the same thing happened... no check mark for completion. That doesn't detract from the enjoyment of it though. Thanks for creating it!

Finally completed this scenario. There was something about stopping at...Cedar Lake, I think it was...When I would just roll through there, it would give me a 'instruction failed' notice. Still took me 65mins to complete instead of the 45 listed, which I'd label as trying to get the train restarted up-grade with only notch 2 allowed (including sand)

Thanks for the scenario.

I ran to Mitchell a bit slower than the speed limit to reach the siding where I was to met the extra. The extra ran the red light at Mitchell and collided with my coal train just short of Mitchell.

A check of the "map" on going back to resume the scenario at an earlier time showed the switches all set for the main at Mitchell even before the extra had started to move. And there was no manual control over the switches so I could not set one for the siding. Oops!

Excellent. This is classic B&O railroading at its finest. Only flaw is the Type G signals.

Very good scenario for this Route. I liked it a lot. All worked fine for me.
Thanks for making and sharing this with us. Cheers, Warren

Hi, I completed the scenario, got 2 ticks, but received an incomplete scenario message and followed by Only stopped at 1 of 2 stops.
Rather strange. But thanks for the scenario.

Avery well done workshop with no problems enjoyed the run and thanks for sharing.

All is working now.

First time this has ever happened to me. Subscribe to 'Bedford Junction Branch' but will not loadup???? Had ran other scenarios with it prior to this problem. So the other scenarios want to add the BJB but not able to.

Well done, GreatNortherner, an excellent and enjoyable scenario.