How to increase fps in CS2?

/h1 Optimal CS2 settings
Here are the best configured parameters for CS2 that will allow you to achieve the maximum number of frames per second:

Screen resolution: Leave it as default, but reduce it to 1280×960 if necessary.
Player contrast enhancement: Enabled. This does not affect performance and will help you play more efficiently.
Multisampling mode: CMAA2. If your computer has good performance, you can enable MSAAx4.
Shadow quality: Low.
Texture quality: Average.
Shaders: Low.
Particle effects: Low.
Ambient occlusion: Low.
High Dynamic Range (HDR): Quality.
FidelityFX: Quality.
Nvidia Reflex Low Latency: Disabled.

These settings will help you achieve better performance in Counter-Strike 2 while maintaining acceptable graphics quality.


/h2 Console commands to increase FPS in CS2
+fps_max 0: Disables the limit on the number of frames per second, which allows you to significantly increase the frame rate.

+engine_low_latency_sleep_after_client_tick: This parameter helps to stabilize the frame rate and eliminate freezes. To enable it, set the value to "true". You can also set the +fps_max 300 command to limit the number of frames per second at 300.

cl_allow_animated_avatars: This command controls the animated avatars of the players. To increase performance, it is recommended to set the value to "false".

-nojoy: This command completely disables controller support, which frees up RAM and reduces the load on the system. To activate, set the value to "1".

+cl_forcepreload: This command provides preloading of the map. This may take a little longer at startup, but reduces the possibility of freezes. Set the value to "1".

+cl_updaterate: This parameter regulates

/h3 CS2 launch parameters
–d3d9ex — allows you to quickly collapse and deploy the game. Reduces CPU load by about 40%.
–high — runs CS 2 with high priority.
–freq X — sets the refresh rate of the screen. Instead of "X", specify the parameter corresponding to the ending of your monitor.
-refresh X — changes the refresh rate of the screen. Instead of "X", specify the desired parameter.
+fps_max 0 — removes the frames per second limit.
+rate 124000 — sets the maximum amount of data that the host can accept (bits/sec).
+exec "file name" — loads a pre-saved configuration.
+cl_cmdrate 128 — sets the maximum number of packets that are sent to the server per second.
+cl_updaterate 128 — sets the maximum number of packets with updates that the server sends per second.
+ex_interpratio 1 — network parameter.
–threads X — instead of "X", specify the number of cores that the processor needs to use.
cl_interp 0 — smoothes the image.
+cl_interp_ratio 1 —

guides

There will be a lot of guides thanks to which you can comfortably play your favorite game

[⭐Zugzwang⭐]

половина команд уже не работает в cs2, но идиоты упорно продолжают копировать друг у друга одно и тоже...

[bonkmaykr]

You should always set your shadow quality to High or Very High if you can handle it, CS2 doesn't render player shadows at all at medium or low and this will give you a competitive disadvantage.