Subscribe to download
A/D converter (no mods) (for survival)

Leave a like and favorite if you like it ❗❗ it really helps out getting it out on the workshop

This is the most responsive converter for its size on the workshop as far as i've seen (that you can build in survival without mods).

Volume = 8 blocks

Keep in mind that when you use a different seat that isnt lvl 5, the responsiveness is as bad, maybe even WORSE than most A/D converters on the workshop.
So its important to note that the bearing should be on 2 degrees in both directions and max speed.

The logic blocks can be replaced by other blocks, since they technically add a 1 tick delay, they are really there to connect the sensors to the body without the use of blueprint editing/glitch welding and to easily see if its actually outputting a signal or not.
------------------------------------------------------------------------------------------------------

Parts list:

1x lvl 5 seat/saddle seat
1x block/6-way part (of any kind)
2x logic gates (AND, OR, XOR)
2x sensors (of any level)
2x pistons (of any level)
1x bearing
1x T-pipe (3-way)
------------------------------------------------------------------------------------------------------

How to make:

1. put down a block or 6-way part

2. put 2 logic gates attached to it on opposite sides with the display facing up.
(AND, OR, XOR)

3. put 2 sensors on the underside of the logic gates facing forwards/backwards while being horizontal without making them face eachother

4. put the sensors to 1 distance
(the singular block space the sensor is looking at cant be obstructed/filled in)

5. connect the sensors to the logic gates

6. put a bearing on the starting block/part between the logic gates

7. put a small T-pipe on the bearing, making its attachment points be up against the sensors
(but dont weld them)

8. rotate the T-pipe 90° with a controller, seat, your hammer or another method
(make sure its off the lift)

9. put a piston on both sides of the T-pipe

10. Besides the LVL 5 seat, delete anything you used to rotate the bearing 90°

11. Connect the bearing to the LVL 5 seat on your creation or just attached to the starting block, press your interact button (E,F...) while hovering over the bearing when holding your connect tool.

12. put both sides to max speed and 2°
(this may not work properly as a client in multiplayer because of a bug the devs wont fix) (so either let the host do this part or host your own world).

13. put it on the lift and use the SENSORS as your OUTPUT (connect to anything you want to control with A/D)
(you can use the logic gates as output as well but they add 1 tick of delay, and are only really there to attach the sensors and display if they are working or not)

Now you are able to use your responsive and compact A/D converter.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------