Abonner for at downloade
JRF Koki107 Container Car

This container car is designed to fit the container sizes (12ft/20ft/30ft) in the collection below.
And mission container(24ft:11x11x29) is supported.
https://steamcommunity.com/sharedfiles/filedetails/?id=2428286442

It is compatible with SW-TCS[wikiwiki.jp] and R-BUS CAT1[wikiwiki.jp].

There is also a model with the front and rear reversed, which can be used when turning back by changing locomotives.
https://steamcommunity.com/sharedfiles/filedetails/?id=2430088537


By pressing the following button for each, the corresponding connector will be activated.

• 12ft: 1 to 5 from the direction of travel
  
• 20ft: 1 to 3 from the direction of travel
  
• Mission Container(24ft): 1 to 2 from the direction of travel
  
• 30ft: 1 to 2 from the direction of travel

After the work is completed, you can turn off the indicator showing valid connectors by turning on the "Connectors Indicator Cut-Off" on the deck.

• After activating the connector on the container side, tighten it with the connector on the freight car immediately. If containers with the connectors on and not tightened are placed next to each other, they may pull against each other, causing destruction, fire, or injury.
  
• If the connector status becomes complicated due to pressing the wrong button, you can release all the connectors by clicking [Reset All Connectors] on the deck. However, for the reasons mentioned above, this operation should be performed after all connectors on the container side have been turned off.
  In consideration of work safety, this specification has been discontinued with the update on April 27, 2021.

R-BUS CAT1 Brake Unit : https://steamcommunity.com/sharedfiles/filedetails/?id=2038343870


Re-uploading (including modification) of this vehicle is prohibited.
This document is a machine translation of a Japanese document by DeepL.