How to stance your car in Brick Rigs

A guide on how to stance your car iin Brick Rigs to get that nice clean look.

Choosing the right car

Step 1

Make sure your car is appropriate for lowering. Your car should be 6-7 wide to get a proper scale.










This car is too small as it is already as low as it can get.











This car again is too big as the fenders are quite low and it uses massive wheels

Getting started

Step 2

For this guide i've chosen this generic police car










Start by removing the wheels and axels:










For this car the fenders are a bit too low, so we will begin by raising the fenders by adding one 2x1 brick under the fenders:










Repeat this for all the fenders

Making the axles

Step 3

Let's start making the axles. Start by making a good camber angle (recommended amount is 7 degrees):










After that make these 2 pieces:










Then make this piece:










And adding these 2 pieces to the earlier one:










And put 2 pieces togehter like this:










And after all that put it all together:










Then make sure you have the axles set up:










Then paint it all the same color if you haven't already:

Placing the component in the car

Step 4

Then press on any part of the component and press recursively connected:










and press c to copy 4 of these:










Then start connecting the wheels:




















After that make sure all the axles are properly set up:










Then you will run into this proplem how these wheels have positive camber, revert the back to normal with pressing shift and using w and s









































There you have it! the car is completed:




















Hope you enjoyed this guide. If you have any questions, be sure to leave a comment! I'll try to respond to all of them :)

[Cheezewheel]

now




to make a civic

[Aarno]

press shift and then angle it

[K24]

How do you get seven degrees with something?

[K24]

umm

[K24]

YOU MADE IT SO HARD TO SEE EACH PIECE SO IM REALLY SAD CUZ DIS DON'T WORK (IN A WAY)

[superdelete]

off havent checked in a longggggggggggggggggggg time but thx :)

[K24]

Hi im a fan u know i met u and i don't quite get the image of trying to get the camber pieces i don't know anything really can u send me a camber piece?

I really into cars and drifting Btw.!

[Aarno]

you press shift and then angle it and yeah it is probably easier now that way but this guide was made in 2018

[superdelete]

how do you make it seven degrees
ik its a dumb question just like choclate cakes one (which is the same question)

[Buck™]

an easier way is to take actuator 1x1x1 and static them and set an angle
easy