Strategic Command WWII: World at War

Strategic Command WWII: World at War

FangoWolf 18. des. 2018 kl. 19.26
Map Mod
Can you change the country list to different countries?
< >
Viser 1618 av 18 kommentarer
gunho 29. des. 2018 kl. 10.45 
ok i figured the flags from patton drives east wouldnt work they are square and the games is round and smaller do you know what size it is and ill look on google for actual size to copy if you think that can work i dont know how to use paint.but if i did lets say on the big file of flags there are quite a few blank white round flags can i use that if i can can you explain how to use that if possible again thanks for all the help.i dont know how to lets say as you say select a israeli flag and paste it over another how is that done.edit i was wrong i just looked at flags there are no blank flags ok but i do have another question as of right now the flag i have is of india british flag i think i see other flags very close to israel color i dont care if its not same its close how can i just change flag of british india to another flag that i see i want is there a number thing to use to switch or how can i paste over thae flags.i hope you understand my question.ill just try that instead of looking on google for same size flag unless that will be easier to do just need the size
Sist redigert av gunho; 29. des. 2018 kl. 10.56
gunho 29. des. 2018 kl. 11.48 
hi bill ok i went into flags im not so good at paint but i did get what i wanted a little sloppy but it will work for now until i can figure out how to get another icon to replace flags with same size and how to input it into flag sprites.i still have problem though my flag for major has chabged but when i take over territory it still shows the british flag on units and when i take over a country still shows the british flag where do i go and change those also thanks.i was looking under flags are the unit nato flags and resource flags are these what i need to change for territory takeover and unit flags.
Sist redigert av gunho; 29. des. 2018 kl. 11.56
Bill Runacre  [utvikler] 31. des. 2018 kl. 8.37 
Hi gunho

There are some files in the main installation's Bitmaps folder that you'll need to copy over to your own campaign's Bitmaps folder.

Essentially any within this folder that include flags should probably be copied over and amended (though if you only use NATO or 3D counters then you don't need to change the other one).

Some of those you'll want to change are:

morale_flag_sprites.png

resource_flag_sprites.png

unit_counter_flag_sprites.png

unit_counter_flag_sprites_zoom.png
< >
Viser 1618 av 18 kommentarer
Per side: 1530 50

Dato lagt ut: 18. des. 2018 kl. 19.26
Innlegg: 18