How do T3 Motion sensors work?

[Kiraiya]

Whenever we try to use the T3 Motion sensors, they just don't work at all.
We press the Trigger in VR, Nothing
We drop it in VR, Nothing
We try the Wall, Nothing
We Try the Floor, Nothing

So how do we VR-Pleps use a bloody T3 Motion sensor?

[weiss]

uh, you putt the T3 sensor onto the ground o.o
thats it, nothing else.

i mean, i dont know what the button to place stuff down in VR mode is but, you simply putt it onto the ground like you do with T1 and T2 which you putt against the wall.

fact is, you can not putt T3 onto the wall. it must be placed onto the ground.

[Kiraiya]

Well, when i set it down on the ground, it does not show up on the trucks map, doesn't do noises, doesn't notify about anything passing through it and does absolutely nothing, apart from looking fancy and sitting there :<
With the T1/2 you hold the trigger and it shows on the wall, similar to Desktop but since this one goes on the floor, it does not do that.

[Maya-Neko]

It will show you its range when placing it. When the ghost enters this perimeter, then the sensor will point towards the ghost and lights up, so that you can look at where it points at. Make sure, that it is spinning around slowly, as that shows that it is switched on.

[Kiraiya]

Originally posted by Maya-Neko:

It will show you its range when placing it. When the ghost enters this perimeter, then the sensor will point towards the ghost and lights up, so that you can look at where it points at. Make sure, that it is spinning around slowly, as that shows that it is switched on.

It does not. No range or anything, when trying to place it. As stated above, using the triggers in VR, does absolutely nothing and just dropping them does not help either.