Need to reset monorail station entrance and exits

[lkmunoz80]

OK so I've got a monorail system. I moved one of my stations slightly, and now I need to move my entrance and exits. But when I click on the station, it shows that I've already met the entrance and exit requirements and now it won't let me place a new entrance or exit. I tried deleting the station completely and the rebuilding it, but each time I do that it still shows I've already got a entrance and an exit so it won't let me add new ones. But I don't have either! Ugh! I've been messing with this for over an hour. How the heck do I reset a monorail station so I can place new entrance and exits? Help please!

[Varick]

Click station, under station list click station you want, click the place or move entrance tab, use mouse to slide entrance to where you want and then click to set. Then, do the same for the exit.

[lkmunoz80]

Thanks for the reply. I've tried this. But when I click on the Move Entrance or Move Exit tabs, nothing happens. The bubbles next to them are already filled in, indicating I've already placed them. When I click them again, it should let me move them. But it doesn't. That's my issue. I can't for the life of me figure out why it's not working.

[grampers62]

Assuming there is nothing blocking path placement around the station you should be able to move the entrance or exit to different part of the station platform.

[lkmunoz80]

Agreed, I should be able to but I can't. After HOURS of messing with it, I finally had to delete my entire monorail and rebuild it. I had six stations that I had not yet connected at all, but they all showed I had an entrance and exit already placed. And the two I wanted to move, I would click the "place/move entrance" or "place/move exit" buttons and nothing would happen. All I can assume at this point is that it was some kind of glitch.