Loading Lumber to 2nd Truck

[Schnipp]

I'm fairly new to Spintires and Mudrunner.

I've started in the beginner mode where I can auto-load trucks with lumber, but now switched to simulation.

I can load 4 pcs of lumber on the crane truck and then activate the 'auto-fill', yet if I put 4 pcs on a 2nd truck that only has the loading bed I can't auto fill that one.
Is that at all possible or do I need to continue to load with the crane? If so, how much lumber do I need to load so the truck will be accepted as a full shipment?

[Mirage]

Be sure you're using the right logs for that other truck, so you're not loading small logs where you need medium and vice versa.
Also you need to change trucks and get behind the wheel of the truck you want to load, it should light up and tell you if it needs more logs or of you need to position your truck better.

[Schnipp]

Yes, I've loaded the 2nd truck up with the right kind of lumber.

Thanks for the help, I'll try that.

[Konscience]

On the same topic, I'm on the C-255 with the short log and crane module (no trailer or carriage, just the on-the-chassis setup) and loaded 10 logs or more on it.
I carried them on the lumbermill but... it say I don't have any load to deliver,
Should this truck be loaded by another truck, even if it have its own crane?
I'm a bit confused and didn't see any prompt for autofill (I'm in hardcore mod also)

[Schnipp]

Thanks, I've solved it.

I had to go into the advanced mode to fill the truck.
With the crane I'm already in the advanced mode due to be able to operate the crane.


@Konscience
You get red or green dots on the lumber, go to advanced mode, hover over any green dot (4 pcs. min.) and you can autofill.

[Konscience]

That was it! Thanks!
So I carried 10 non-secured logs over 2km while driving like a pig, lmao.