Why do jet engines flameout when manuevering with an aircraft? :: Stormworks: Build and Rescue General Discussions

Store Page

Stormworks: Build and Rescue

All Discussions Screenshots Artwork Broadcasts Videos Workshop News Guides Reviews

Stormworks: Build and Rescue > General Discussions > Topic Details

Anal_Torpedo has Stormworks: Build and Rescue

Nov 2, 2018 @ 7:04am

Why do jet engines flameout when manuevering with an aircraft?

I've been encountering this problem lately.

Last edited by Anal_Torpedo; Nov 2, 2018 @ 7:09am

< >

Showing 1-7 of 7 comments

Existential Dread has Stormworks: Build and Rescue

Nov 2, 2018 @ 7:22am

Well it's a real problem that occurs IRL on some aircrafts. If the angle of attack is too sharp it can lead to a compressor stall because the engine can't get enough air anymore. You can probably look that up on google.

Anal_Torpedo has Stormworks: Build and Rescue

Nov 2, 2018 @ 7:35am

Yeah i know that, but it occurs like 99% of the time even if it's just a simple roll.
Also only just one engine goes out from the two

Existential Dread has Stormworks: Build and Rescue

Nov 2, 2018 @ 8:00am

Don't know then, sorry.

Vanessa Doofenshmirtz has Stormworks: Build and Rescue

Nov 2, 2018 @ 7:16pm

It could be overspeeding. If an engine doesnt have a throttle limiter then if it goes over, i believe 200 rps, it will flame out and die. I could be wrong, but i sugguest you go check out some of MrNJersey's videos. He made one on making jet engines work properly and it didnt flame out. If it isnt overspeeding then its probably just a glitch. Hope this helped some...

WhiskeyJim68 has Stormworks: Build and Rescue

Nov 3, 2018 @ 5:34am

I had the same issue...wound up being too much RPS like snicker mentioned.....my threshold seemed to be around 190 RPS before fire. My particular setup runs stable at about .18 throttle after it gets airborne.