New atmospherics with IC chip

[dupa]

I am trying to set up the H2 Combustor to automatically make water. So, I put in an IC chip into the newly added slot. It's programmed to turn the combustor on/off under certain conditions. Of course, when the combustor switched off, the IC chip stopped working. When I tried changing the "Activate" property rather then "On", it didn't seem to do much.

So, what is the point of this IC slot if I need an external IC housing anyway? Maybe I'm missing something?

[GuyMonkey]

Don't use "On", but use "Mode" instead to switch between "Activate" (1) and "Idle" (0)

[dupa]

Thanks, I'll give it a try

[dupa]

Well... It didn't work. "Mode" is 0, but the combustor is still combusting. Back to external IC housing.

[dupa]

So, the solution I came up with is to use a pressure regulator on the fuel line. This way you can control the combustion by limiting the fuel supply. It will also not burn the whole fuel tank at once.

[GuyMonkey]

If "Mode" isn't working then it is a bug, as "Mode" is for all atmospherics the intended way to control the activation

[dupa]

I'll check it again, maybe I was wrong. Maybe the fact that I flew into the stratosphere because the combustor was so hot has something to do with it.

[dupa]

So I checked it again. It's definitely combusting when "Mode" is 0.