Help solder

[corsica-man]

I try 3 Time to create solder but anytime my furnace explode, please help me

[Hardly]

Are you smelting with raw ice chunks, or do you have a gas pipe setup? If you're just using ice chunks, only put a very small amount in - I have found that just 1 oxite and 2 volatile ice provides a sufficient temperature/pressure environment to make solder with - although it won't last very long, so it's best to put all the ingredients into the furnace (including the ice) before you ignite it. Also, make sure that your reagents are exactly the right ratio (check the ereader cartridge for your tablet if your not sure what that ratio should be - the ereader will also tell you what pressure and temperature conditions the alloy needs to make it successfully)

[corsica-man]

I do with pipe system connected at tank of mix 90/10 o2 H

[corsica-man]

Its 0.5/0.5 ration , it’s alright? , if i put 19 of lead and 19 of Iron it doesn’t work

[Starshard0]

You aren't getting the proper temperature/pressure in the forge. You can't just throw iron and lead in and expect it to work. You need to keep an eye on the gauge on the front of the furnace, and make sure you are getting it within the proper range.

[corsica-man]

What is the good pressure please

[corsica-man]

And the good temperature

[Magnus Skipton]

Originally posted by corsica-man:

And the good temperature

I can't recall on the top of my head, but the info is in the ereader.

[Axcess]

All the info about temp and pressure can be found in your tablet with the (eReader) cartridge installed.

[Hardly]

There's also a wiki page where someone has worked out the optimal gas mix and pre-ignition pressure to reliably produce each alloy: https://stationeers-wiki.com/Furnace