What do I do when walkway ramps/stairs don't reach platforms?

[ShowTime13]

What I mean is dumb situations when the stairs almost reach the platform, but don't.
Wish they were procedural, so they height is variable, but rn they either align or not. That's frustrating.

[Dirtyshadow]

To avoid this you should start any new builds by locking a 2m or 4m piece to the world grid.
If you use a 1m piece you sometimes don't get height alignment right.

Else the only way is to be creative with the 1m or 2m foundation/ramp/stairycases to line up the walkways.

[PsYcHo_O]

In the worst case you can always start at the top and clip into the ground. But there is not much you can do about unaligned pieces.

[untmdsprt]

Oh good it's not just me being frustrated with these damn things.

[Harag]

Originally posted by untmdsprt:

Oh good it's not just me being frustrated with these damn things.

I'm in that club too. Arrh, need to design my boxes better. :)

[kLuns]

If the floor is more than 1 meter thick you can clip a part into the floor.
But in some situations you might be screwed :p

Originally posted by untmdsprt:

Oh good it's not just me being frustrated with these damn things.

I'm with you on this one.
4m World grid foundations prevent most problems on a new build.