[fixed] Liquid Pipe Thermo Sensor

[AtoK]

I've build the liquid pipe thermo sensor from steel. It shows a internal temperatur of -273.2°C. I deconstructed it and rebuild it, it shows the same temperatur. So the setup for a green signal over 0°C is not working. My liquid which runs through the sensor got 25°C-30°C.
Can anybody help solve this issue for/with me?

picture [ibb.co]

[Big Hat Logan]

Pipe thermo sensors show the last temperature of a liquid passed through. If no liquid passed through yet, it shows 0 K (-273.2° C) as temperature. However, you said, the sensor still says 0 K altough the liquid passed through. The only suggestion i can give is to verify that the liquid really passes through. If that does not help, try deactivating mods. I just verified that the latest version of ONI at least works as stated above. On my machine, that is, of course.

[AtoK]

Thx for you'r reply.
It was completely my fault: I've build that sensor in vacuum, the zero k are good there. Than I don't build the pipe through the sensor, I've build it beside the sensor, so the liquid wasn't passing through...

[John Hadley]

I think the game used to show -273C for sensors when there was no materials in the pipe in the past but that was changed and they now just remember the temperature of the last packet to travel through them, so once you have a pipe connected and some material has flown through it, the sensor shouldn't ever read -273C anymore.