MatingIntervalMultiplier question

[Connery]

if I were to set MatingIntervalMultiplier to 5.0 does that mean it will be ready to mate again 5x faster or 5x longer?

[Machyna]

faster

[Connery]

ty

[Stijger]

This is not correct :) it's longer

[GP]

It's 5x longer.

Interval = longer (when given a higher number)
Speed = faster (when given a higher number)

[Stijger]

exactly ;)

[Legion505]

So you should put 0.5 correct to decrease the time it takes on the interval and 5.0 on the speed

[Greystar]

Originally posted by Legion:

So you should put 0.5 correct to decrease the time it takes on the interval and 5.0 on the speed

^^ this is correct information.

[Red River]

I set mine to .1 and it still takes around 4 hours. that's a lot of time in SP because everything is real time and the clock stops after exiting...

[GP]

Originally posted by Red River:

I set mine to .1 and it still takes around 4 hours. that's a lot of time in SP because everything is real time and the clock stops after exiting...

Then go lower, try .01.

[Car]

0.1 takes 2 hours

[Sukotto82]

mating interval isn't a set 2 hours or 4 hours it's a random range.

I forget exactly where mine is set but it takes between 1 on the low end and 6 on the high end depending on the dino I'm breeding before they mate again.

I also have maturation speed at 6.0
and imprint frequency interval at 0.1
so far I haven't had anything I can't imprint but I've only started not long ago on this setting and only raised rex, argent, ptera, trike, anky, featherlight, and stego. all have had 100% imprint most with just 1 interaction but the rex took 3 imprints.

hope this helps a little.
I don't know the range of 0.1 specifically but I see some people say 2 hours some say 4 hours and they could both be right so no reason to call people names (looking at you alexilies764).

[Wayne]

This thread was quite old before the recent post, so we're locking it to prevent confusion.