Pedals do not work, car doesn't move, tried binding 4 times

[DTMUniversal]

I have Simjack Pedals, game recognizes it and I've binded it and rebinded it 4 times.

I've turned on and off invert, IS slider.

In the practice pit lane, all my other controls work, the game recognizes the pedal bindings, but the car never goes past 1km/hr, it just stays there, stuck in whatever gear I put it in, and won't move forward.

If I have invert turned ON, the engine revs to max but still the car doesn't move forward.

I tried to see if it was an ignition issue but it wasn't, switched between Beginner and Pro and the car ignition is turned on.

Tried switching gears, it switches, but the car doesn't move.

Help?

[Estrichleger]

I have the same problem with my G29. It recognizzes it but it does not work in the gme

[TommyFresh]

Make sure you select your peripheral at the top and select "Throttle AXIS" not just "Throttle"

Maybe I'm just slow but took me like 10 minutes to figure out why my pedals wouldn't work.

[DTMUniversal]

Originally posted by gjettermann:

Try to invert the brake axis, if you have a handbrake try the same

I already tried that as I mentioned in the post. Turned invert On, Off, nothing.

[gjettermann]

Do you have a handbrake conected try to invert the axis

[Burtis]

Originally posted by Estrichleger:

I have the same problem with my G29. It recognizzes it but it does not work in the gme

Same here cant get the game to recognize my g29 inputs

[vukom]

same. simjack pro pedals. bound to throttle / brake axis. won't go past a couple of km/h

[Nicolai.Summerfield]

I'm having the same issue. Did you figure out a solution yet? Super frustrating!

[Niak]

same here, it was working before the update, g920

[wovlejr]

I had the same issue but resolved it. I was using a Moza R5 with its pedals and later switched to SimJack Ultimate pedals. After calibrating them with SimJack software, the game detected the pedals, and I bound the throttle, brake, and clutch. However, there was no response when accelerating.

After trying many fixes, I discovered the issue: when both the Moza R5 and SimJack pedals were connected, the game still had the Moza R5 pedals bound to the controls. Unplugging the Moza R5 allowed the SimJack pedals to work. Finally, I cleared the bindings for the Moza R5 in the game settings and applied the changes. The SimJack pedals then worked perfectly. Hope this helps!

[DTMUniversal]

Originally posted by wovlejr:

I had the same issue but resolved it. I was using a Moza R5 with its pedals and later switched to SimJack Ultimate pedals. After calibrating them with SimJack software, the game detected the pedals, and I bound the throttle, brake, and clutch. However, there was no response when accelerating.

After trying many fixes, I discovered the issue: when both the Moza R5 and SimJack pedals were connected, the game still had the Moza R5 pedals bound to the controls. Unplugging the Moza R5 allowed the SimJack pedals to work. Finally, I cleared the bindings for the Moza R5 in the game settings and applied the changes. The SimJack pedals then worked perfectly. Hope this helps!

But I only have my wheelbase and pedals connected. I don’t have 2 sets of pedals.

I’m using Simagic Alpha and Simjack Pros.

[Sassanid]

Disconnect any other controllers, gamepads, etc