Speed Limit editing - possible for scenario only?

[Irascible_SAP]

I'm struggling to find some information - I have found lots of information about setting speed limits on a route, but this all has been in relation to route building which means permanent changes to the route and that is not my aim.

I simply want to change the speed limits on the route inside of a scenario only - is this possible and if so, how would I go about it?

[pjohnandlyns]

1. Yes it is.
2. Not all routes have the required signage so if the route your scenario is on doesn't, then you will have to add a route from the "Asset Providers" list that does and use those. You will find them under the Bag (Miscellaneous) icon.
3. Open scenario as normal in editor and go to the place where you want to put the TSR. Decide what speed you want.
4. Click and place a TSR board with your speed on it where you want it to start.
5. Click and place a TSR "T" (termination) board where you want it to end.
6. In top left fly out cilck on the lined square and place marker at start of TSR then drag other box to the "T" board. In the right fly out, alter the TOP line speed to your TSR speed.
7. Click and place TSR warning board approx; 1 mile from start of TSR (along with a TSR speed board same as you placed in 4 above) to tell the driver what speed to expect.
8. You can if you wish, place short siding markers at the start and end of the TSR that will show on the HUD line profile to tell the driver how long the TSR is.

When the front of the train reaches the first board the line speed will show your speed and when the rear of the train passes the "T" board line speen will revert ot normal.

This TSR will only be on the scenario you're creating, not the route itself.

Hope this helps.

[Irascible_SAP]

Thanks :)

[pjohnandlyns]

You're welcome.