Hologram: RGB alignment issue

[GM Pax]

The levers won't move far for any of the three, and they cannot be lined up.

Am I missing something ...?

[Grey]

Probably a pancake issue.

[Morrigan [FA]]

Make sure pancake is complete and fuses are valid. As for lining up, I find it easier to do when its pixelated so I leave that module for last.

[GM Pax]

Fuses were all good, and the pancake was green-light valid (and met the requirements in the grimoire). :shrug: Levers just refused to turn more than about 1/8 of a circle, all three of them.

I'll try again later, I guess, and just hope?

...

My problems lining things up weren't an inability to see what was moving where. It's just, the Red was so far to the left, and wouldn't go far enough to the right .... while the Green and Blue were both far to the right, and couldn't come far enough left, for all three to line up.

[illegal legos]

dumb question: Do they move the other way?

[GM Pax]

Originally posted by illegal legos:

dumb question: Do they move the other way?

They move either direction, but NOT in a full circle. I get, maybe, 1/8 of the circle to move each lever back and forth within. And not the same arc for each, either.

[Grey]

You should share some screen.

[Daff]

If the levers dont move the fuse might be busted.

[GM Pax]

I don't know if it was a bug or what, but when I went and tried again, all the levers moved just fine.

[GM Pax]

Originally posted by Grey:

You should share some screen.

A screenshot would be useless, as it wouldn't show the inability to move those levers.

[Grey]

Yes I know. It's for the setup.

[GM Pax]

Originally posted by Grey:

Yes I know. It's for the setup.

Doesn't matter now anyway, I managed to successfully complete the repair. :)

[Grey]

Nice !

Don't hesitate if you have more questions.

[Xavier The Neon Tiger]

Just came here with the exact same issue (levers that would only complete a quarter circle, unable to make the colours overlap).
It was, in fact, a pancake issue, thanks for that.