Steam Deck

Steam Deck

jgkg Jan 13, 2024 @ 10:43am
New OLED left thumbstick drift in <24hrs...
Just opened my steam deck yesterday and tested it out on CP2077 to see if there were any issues. It was playing great all of yesterday, then I left it to charge on my desk overnight. When I grabbed it this morning, in the middle of playing my left thumbstick is now in a permanently drifted down position.

Already tried restarting, low level calibration through desktop mode, and factory reset
Last edited by jgkg; Jan 13, 2024 @ 10:46am
< >
Showing 1-6 of 6 comments
Mahjik Jan 13, 2024 @ 10:46am 
Have you checked using the SteamOS controller test? It's in Settings -> Controller -> Test Device Inputs.
jgkg Jan 13, 2024 @ 10:49am 
Originally posted by Mahjik:
Have you checked using the SteamOS controller test? It's in Settings -> Controller -> Test Device Inputs.


Originally posted by element109:
Check the dead zones in controller settings.

Yup, have checked both - device input test shows it's drifting towards bottom right. Deadzone adjustment doesn't help with not being able to put the thumbstick in the up position.
Last edited by jgkg; Jan 13, 2024 @ 10:50am
Mahjik Jan 13, 2024 @ 10:55am 
Originally posted by jgkg:
Originally posted by Mahjik:
Have you checked using the SteamOS controller test? It's in Settings -> Controller -> Test Device Inputs.


Originally posted by element109:
Check the dead zones in controller settings.

Yup, have checked both - device input test shows it's drifting towards bottom right. Deadzone adjustment doesn't help with not being able to put the thumbstick in the up position.

You seem tp be describing two different things. Just to clarify, you said "not being able to put the thumbstick in the up position". Are you saying when you do the Input test, pushing the thumbstick "Up" does not register any input?
jgkg Jan 13, 2024 @ 11:02am 
Sorry, it registers the input. The highest input I can get is to the controller deadzone, and when checking the deadzone the base position is well below the default deadzone bottom border
Mahjik Jan 13, 2024 @ 11:05am 
Originally posted by jgkg:
Sorry, it registers the input. The highest input I can get is to the controller deadzone, and when checking the deadzone the base position is well below the default deadzone bottom border

Take screenshots of your config screen showing the lack of full movement and start a support ticket with Valve. If you are used to small electronics, you could open it up and see if there is either some restriction to the thumbstick or just unplug the connections to it and replug them in to see that addresses the issue.
invision2212 Jan 13, 2024 @ 12:17pm 
try this. it worked for me about 6 months ago when i installed new sticks.

https://www.ifixit.com/Guide/How+to+Calibrate+Steam+Deck+Thumbsticks/150415
< >
Showing 1-6 of 6 comments
Per page: 1530 50

Date Posted: Jan 13, 2024 @ 10:43am
Posts: 6