How can I cut straight to burning the body?

[Phileosophos]

First, thanks to those who helped me out yesterday. Armed with the knowledge of how to get into the demon database, my second shift was a complete success by comparison. I was certain of the demon's name halfway into embalming the second body. All that remained was to figure out which vessel.

I was pretty sure it wasn't the first or second, and sure enough I was convinced it was the third body seconds after wheeling it out. I grabbed the mark I'd prepared, put it in place, and... couldn't use the gurney. In fact, I couldn't use the gurney again until I'd finished embalming the body completely. I tried after each successful step to see if the key press was available to use the gurney, and it wasn't until after I'd finished the final step. And I had to remove the mark to continue with the embalming!

I was afraid the whole time I was about to lose, and frankly the increasingly crazy hauntings and what not were just irritating and annoying when I just wanted to burn the body. So, as the subject line asks, how can I cut straight to burning the body once I'm sure?

[Topdog]

You need to do the embalming of the body you want to burn, only then does it contain the reagent that the tapes/database tell you is needed for binding the demon to its correct mark .

Otherwise it can avoid being burned

[Phileosophos]

That's a good point. If I'd had my way, I'd have jumped the gun and burned it without that special "baleful liquid" or whatever it's called. But I guess I thought I could short circuit the process. Oh well.