10 Step Guide to Use Standable

***THIS IS OUTDATED***

1. Install Standable

2. Setup your trackers
2a. launch just steamvr and goto your settings
3a. in controller settings, access your trackers and set each tracker to its own tracker designation (head, set to head, chest, set to chest, etc)

*NOTE - when you launch steamvr you are already in standables calibration mode

3. set your controls on the ground visible by your headsets camera or base stations and then stand up to create distance from your controls (you may want to take a step back or so). This will calibrate your floor height

4. physically t-pose and flick your wrists down to finish standables calibration

5. launch your selected app
(for most other apps you should be fine with just this process, but for VRchat you need to do this)

6. Once loaded into VRchat and you have your selected avatar ready, start VRchats calibration mode (standables calibration mode should NOT be enabled prior to vrchats calibration)

7. physically T-pose and flick your wrists down to ENABLE standables calibration mode, you should now have vrchats and standables calibration mode active

8. physically T-pose and flick your wrists down to finish calibrating with standable

9. finish calibrating with VRchat

10. you should be all set, if you have any questions put them in the comments and I should get to them

Guide

[Not Martian]

@eikonik standable does not work with virtual desktop due to the tracking fighting against each other you can only use one of them at the same time

[Sparrow]

@I... Am Steve I'd check the standable discord and use the FAQ channel, this is an old guide

[Kitten]

when my controllers touch the hip my whole body moves, how do i fix that?

[eikonik]

the only issue that i have is the tracking is bad for virtual desktop

[🟢GreasyWeezy-λ]

where the hell is standable 2

[Sparrow]

@Luigig what issue do you have? This is a pretty rough guide but I should be able to help a lil

[Elmers]

not working for me