How to Wire a Light to Multiple Switches

You might have discovered that some of the houses you can buy in House Flipper 2 come with lights that are wired to multiple light switches. If you're asking yourself, "How do I do that in my own house or one I'm flipping?" then this is the guide for you!

House Flipper 2: Wiring a Light to Multiple Switches

Step 0 - Prep Work

Before proceeding, simply make sure you have a light (of any kind) and a switch at the ready.

Step 1 - Wire the Light to the Switch

Equip the "Edit Wiring" Tool and wire the light and first switch you wish to use it with like normal.

Step 2 - Duplicate the Light Switch

Equip the "Flipper" Tool and change it to its "Duplicate" function. Duplicate the light switch and place it where you would like; bear in mind, you may always move the light switch later, so just make sure it's accessible.

Step 3 - Done!

Ta-da! If this was successful, you should now be able to see that the light is wired to both switches, and thus, will be toggled on or off at both sites.

Thank You!

Thank you for checking out my guide for House Flipper 2! I hope it was helpful to you. If you have any questions, please feel free to comment below.

[tatiana]

I simply want to make sure your readers know as well :)

[Quantum Boogaloo]

@tatiana Yeah, I know

[tatiana]

I have a couple tips for you, which you might want to add to your guide:
- Before duplicating the light, switch it on. Placing additional lights is much easier if you can see where the light falls.
- Once a switch is connected it wouldn't disconnect even if you destroy the wall it's been placed on and the switch falls to the floor! So feel free to move it - even to another room if necessary.
- If the ceiling slopes and you cannot place a ceiling light, you can place a spotlight on the wall instead - it would still make logical sense.