Steam telepítése
belépés
|
nyelv
简体中文 (egyszerűsített kínai)
繁體中文 (hagyományos kínai)
日本語 (japán)
한국어 (koreai)
ไทย (thai)
Български (bolgár)
Čeština (cseh)
Dansk (dán)
Deutsch (német)
English (angol)
Español - España (spanyolországi spanyol)
Español - Latinoamérica (latin-amerikai spanyol)
Ελληνικά (görög)
Français (francia)
Italiano (olasz)
Bahasa Indonesia (indonéz)
Nederlands (holland)
Norsk (norvég)
Polski (lengyel)
Português (portugáliai portugál)
Português - Brasil (brazíliai portugál)
Română (román)
Русский (orosz)
Suomi (finn)
Svenska (svéd)
Türkçe (török)
Tiếng Việt (vietnámi)
Українська (ukrán)
Fordítási probléma jelentése
First of all (for me), I need to have a mask that's actually large enough to adequately cover my gigantic mug and also accommodate my beard. Otherwise either the mask barely reaches below my chin or it tends to slip off the tip of my nose.
The good news is that I've finally located (and acquired) both disposable and reusable masks that are big enough (without being too large) to keep my face covered without fogging up my lenses when in use.
All my masks have the wire thingie that can be conformed to hug the bridge of my nose. This is an absolute must for me. So when I get the top of the mask to fit close to the bridge of my nose and then pull it up high enough to fit flush against my face (just below my eyeglass lenses) no fogging occurs.
I also make it a point to inhale through my nose and exhale through my mouth whenever I'm wearing my mask, and that helps too.
I hope this helps.
🙂
Put on the mask the right way and make sure the metal stripe closes arount your upper nose. There may be slight foggyness now and then, but nor more (rather less) than there usually is when temperature or moisture in your enviroment suddenly change (leaving or entering a climate conrtrolled building on a rainy or cold day).
I think it's most important to make sure your mask fits snugly all the way across the top of your face because that's where warm moist air comes from that fogs up glasses.
When masks slip down they tend to open a gap where exhaled breath escapes and, being warmer than the surrounding air, it rises straight up and forms condensation (fog) on lenses.
I wear glasses with large lenses (56mm) because I have such a wide face, and they help to form a snug seal along the top of my mask because the bridge of my glasses rests squarely on top of my mask's nose bridge wire when I'm wearing a mask.
(I hope all that makes sense.)
You could get a mask with a nose clip, use antifog wipes or spray.
If those don't work, I just simply let me nose free.
2. No, never needed
3. Of course, its just a pair of glasses not a riot helmet
4. No, and no to 1 because of this exactly
5. My glasses are like 2 months old so not yet
6. Of course. I am not blind. It's just very blurry after like half a meter away.
7. I stepped on my old pair. Lens was
8. Yes. I can't watch tv while lying sideways.
9. No. I hate cleaning it.
10. Tried but it was extremely uncomfortable.
11. No.
12. Not really.
13. No. Too much effort.
14. No
15. No
16. No
17. No
18. It is
2. No.
3. Yes.
4. Yes.
5. Yes.
6. Yes.
7. No.
8. No.
9. No.
10. No.
11. No.
12. No.
13. No.
14. No.
15. Yes.
16. No.
17. No.
18. No.
I have a question to other people wearing glasses. How do you wear them with masks without making it foggy? [/quote]
wat ppl above have said i couldnt be bothered reading, i do like a crisscross witht that thing that goes around the ear then u sort of mould the nose part with the glasees to stop the heat or watever it is going into ur glasses, orr dont wear a mask
I do the same thing