i ned a good advice for overclock ZOTAC GPU :D PURE NOOB

[shrub]

hallo my zotac 970 omegs is arrive : D i am vary happy, i can play evry games wat i enjoy in 1080p minimum 60 fps ultra max settings...but...

i want to buy a 1440p monitor and do same perfom for my games in 1440p mode

i think i ned to do a overclock for this but I DONT HAVE TOO MUCH EXPERIANCE FOR DOING : O

i was do sm,all exparimant in my old amd 7870 but i was a greedy man and do a fry on my card WAS BURN AND MAKE SMOKE : O

i buyed this card becase is design for do a overclock and also is vary good for power using also low temprature control but i want to know wat is best balance to get bonus perform but less risk for do a damage

example is do 1443 gpu clock speds/3523 memory speeds FROM THE BOX NO OC i would like to do a 1500+ megahrtz's gpu also 6000 megahrtz's memory speeds

is posibel or wat? : o

i have this softwares for do a overclock
msi afterburn
zotac fire storm

i have this softwares for do a benchmark
3d mark
(score now in firestrike test 1080p = 8665)

unigine free version VALLEY 1.0
(FPS = 89.9/SCORE = 3757 ON ULTRA/1080p/ AA x 2)

my systam is like this

cpu - i5 4670 OC 4.2
motherbord - asus maximums vi
rams - 2 x 8gb duel chanel 800 megahrtz's
gpu - zotac 970 amp omega edition
power - corsair rm650
hard drive - toshibo ssd

tanks for assist me, peace and love from shrub

[yberkurko]

When overclocking don't aim for spesific clock speeds, but go step by step.

(edit.) First raising power target to near or to max value so it won't limit the card.
Then overclocking core in small bumps untill you can't run unigine valley test and then bump voltage bit if card isn't running too hot already and go on bumping core clock untill you can't go higher. If core temps under full load are still fine leave it there and start bumping memory clock untill it becomes unstable and then small bump back so everything runs stable and you are done.
I like using MSI afterburner, but it's really up to you.
Don't keep multiple graphics card overclocking softwares installed at one time though as it may cause trouble.

[shrub]

Postat inițial de yberkurko:

When overclocking don't aim for spesific clock speeds, but go step by step.

(edit.) First raising power target to near or to max value so it won't limit the card.
Then overclocking core in small bumps untill you can't run unigine valley test and then bump voltage bit if card isn't running too hot already and go on bumping core clock untill you can't go higher. If core temps under full load are still fine leave it there and start bumping memory clock untill it becomes unstable and then small bump back so everything runs stable and you are done.
I like using MSI afterburner, but it's really up to you.
Don't keep multiple graphics card overclocking softwares installed at one time though as it may cause trouble.

ok thanks for this tips i will do like you saying small step and after check temp etc is ok : )