PixelNuts 2014 年 9 月 23 日 上午 9:10
Which cooler is the best to use in a i5 4570? A Corsair A70 or a Coolermaster Hyper 212X?
The question is on the title :)
< >
正在显示第 1 - 15 条,共 21 条留言
_I_ 2014 年 9 月 23 日 上午 11:13 
both are similar

the a70 is old, havent seen new ones in a long time
if you have one, use it, else get a 212+/evo/x
PixelNuts 2014 年 9 月 23 日 下午 12:48 
I think I'll buy a Hyper 212x then. And what about thermal pastes?? I was looking for a good thermal paste like Artic Silver 5 but in the shop where I'll buy they doesn't sell AS5. So I was thinking about in buying a MX-4, but, it's unavailable, then I found the Deep Cool Z5, is it a good thermal paste?? Is it better than Artic Colling MX-4?
TeKraken 2014 年 9 月 23 日 下午 1:25 
The Hyper comes with paste.

_I_ 2014 年 9 月 24 日 上午 1:55 
lots of room, it iwll fit

the cm paste is as good as as5 too, no worries there
PixelNuts 2014 年 9 月 24 日 上午 8:39 
Ok, I measured using a ruler and then I realized that it will touch on the graphic card. What can I do now?
_I_ 2014 年 9 月 24 日 上午 9:03 
what board do you have?

you can mount it facing up if the ram is low profile
PixelNuts 2014 年 9 月 24 日 上午 9:12 
my motherboard is this: http://www.gigabyte.us/fileupload/product/2/4492/8140_big.jpg
the graphic card is located on the first slot
最后由 PixelNuts 编辑于; 2014 年 9 月 24 日 上午 9:12
rotNdude 2014 年 9 月 24 日 上午 9:32 
引用自 Lawliet_GamerBR
Ok, I measured using a ruler and then I realized that it will touch on the graphic card. What can I do now?

It won't touch your video card.
PixelNuts 2014 年 9 月 24 日 上午 9:46 
Maybe I measured it wrong, but using a ruler it touched the graphic card,is there how change the graphic card location in this motherboard?
rotNdude 2014 年 9 月 24 日 上午 11:23 
Once again, it won't touch the video card.
Pomelo 2014 年 9 月 24 日 上午 11:32 
引用自 Lawliet_GamerBR
Maybe I measured it wrong, but using a ruler it touched the graphic card,is there how change the graphic card location in this motherboard?
Make sure you measured with the fan facing the right direction in your calculations. You won't have the fan facing towards the GPU.
PixelNuts 2014 年 9 月 24 日 上午 11:39 
引用自 Powl
引用自 Lawliet_GamerBR
Maybe I measured it wrong, but using a ruler it touched the graphic card,is there how change the graphic card location in this motherboard?
Make sure you measured with the fan facing the right direction in your calculations. You won't have the fan facing towards the GPU.
I measured(and I made a piece of paper using the real measure) like if the cooler is positioned vertically and its underside touched the gpu
Pomelo 2014 年 9 月 24 日 上午 11:44 
引用自 Lawliet_GamerBR
引用自 Powl
Make sure you measured with the fan facing the right direction in your calculations. You won't have the fan facing towards the GPU.
I measured(and I made a piece of paper using the real measure) like if the cooler is positioned vertically and its underside touched the gpu
Really doubt that. I have a similarly large cooler in my PC, and my motherboard is mITX, so another size smaller than yours. There's enough space between the cooler and the GPU (which is a Gigabyte WF3 770).

I could only see it touching the GPU if your card was some uncommon older model by I think MSI(?) that had this weird small addon piece on their back.

Otherwise motherboards are usually designed to hold even larger coolers than the 212 fine.
PixelNuts 2014 年 9 月 24 日 上午 11:51 
I cut a paper(yes I did it) with 15,8cm and tried to put in the place where the cooler goes,but, like you said,maybe I measured it wrong, so do you think it will fit?
最后由 PixelNuts 编辑于; 2014 年 9 月 24 日 上午 11:51
< >
正在显示第 1 - 15 条,共 21 条留言
每页显示数: 1530 50

发帖日期: 2014 年 9 月 23 日 上午 9:10
回复数: 21