安装 Steam
登录
|
语言
繁體中文（繁体中文）
日本語（日语）
한국어（韩语）
ไทย（泰语）
български（保加利亚语）
Čeština（捷克语）
Dansk（丹麦语）
Deutsch（德语）
English（英语）
Español-España（西班牙语 - 西班牙）
Español - Latinoamérica（西班牙语 - 拉丁美洲）
Ελληνικά（希腊语）
Français（法语）
Italiano（意大利语）
Bahasa Indonesia（印度尼西亚语）
Magyar（匈牙利语）
Nederlands（荷兰语）
Norsk（挪威语）
Polski（波兰语）
Português（葡萄牙语 - 葡萄牙）
Português-Brasil（葡萄牙语 - 巴西）
Română（罗马尼亚语）
Русский（俄语）
Suomi（芬兰语）
Svenska（瑞典语）
Türkçe（土耳其语）
Tiếng Việt（越南语）
Українська（乌克兰语）
报告翻译问题
讨论规则及指引
举报此帖
If i remember corectly igorslab showed 450w for few ms on non oced 3080FE. 3090 should be much higher.
I am still waiting on my 3090, but under normal use I don't see it actually using more than 750w.
Your PSU has a +12 Volt rail with 62 Amps and max 744 Wattage towards it. So it's isolation just a little part of the wattage for smaller components such as the motherboard, which will be enough for it to still boot. If you have random booting problems or a black screen sometimes, when first starting up, you will know it's a shortage on the PSU end.
You won't get to the point of crashing out during gaming, loading the operating system, etc.
It will depend what brand/model of RTX 3090, but one without overclocking should have no issues. The flagship founders model of the RTX 3090 has a 350 wattage pull. It would be the overclocked and custom triple fan setups which would use more.
Factor in your monitor usage, motherboard, cpu (AMD tends to use more juice than Intel), solid state and hard drives, and the other components usage for a total wattage ideal, then make sure when everything upon that is maxing out, it's still has some room to flex below the 80 PLUS rating of efficiency.
You have the highest, 80+ Titanium. 96% efficiency at 50% load and 90% efficiency at 100% load. So try just keep that running at a max load of 90% for 100% stability. It then had 10% more headroom to flex, but could become randomly sometimes unstable then or just waste power, while increasing it's fan noise and heat usage.
Real Power Consumption Calculator:
https://outervision.com/power-supply-calculator
Yes as test ive seen say they pull around 320w tdp to 360w tested (without OC), will be ok. Need 3 8 pin powers tho.
This is a lot easiler to calculate with all the specs.
You need to know motherboard + cpu, ram, graphics card brand/model, monitor, drives, etc. There's a power draw from each component in your PC, but the graphic card takes the most.
The Intel 10700k can draw up to 300 watts, even if overclocked.
Then the standard RTX 3080 draws additional 320 watts.
So that's 620 watts, plus some smaller components with more draw.
Add another 20-40 watts for an LCD monitor (depending on it's resolution and screen size).
Your motherboard probably uses 50 to 150 watts (depending on brand/model/series), and each stick of memory requires about 15 watts.
A drive draws wattage slowly over time, so it's probably 2 watts each. 5 drives could be 10 watts.
Do you also have a DVD player or anything else?
Now it might be getting up to 770 watts at max load times, which is where it becomes risky and unstable, if that's the case. Or it just refuses to boot correctly at random times, because a device will drain the power from another and prevent it from starting. Newer and higher-end PSUs will however isolate these rails, specially low power from high power, and again with the PCI-e power connectors (going to the graphics card). So you won't get that drop out as bad like you use to in the past.
The other thing is the amps over those rails. Some PSUs will offer much higher amp ratings, while cheaper ones will tend to share both wattage and amps between the rails (meaning one could drain the other easier).
It's why I dropped this URL to help out:
https://outervision.com/power-supply-calculator
You can use the "BASIC" version, unless you have a complex build with a water cooling pump, etc.
I'm not to much of an expert with pc building, do any psu come with 3 8pin power connectors? Im looking at my pc build and its one connector that splits from one cable into 2 8pin
Sounds like 850w should be the minimum, I dont have a optical drive and will be using an AIO cooler system with standard amount of case fans. Other than XMP and if the 3080 bought is already an OC card, i wont be overclocking. Do you think I should sell my brand new 750 corsair for an 850 one?
3080 https://imgur.com/a/1kK0A0a
If it's brand new with a receipt, can you return it?
Just claim the PC doesn't boot sometimes and ends up with a blank monitor. Then you saw that the graphic cards used in it recommends 850W or higher. So is it possible to replace it with a higher watt model.
They should happily trade you with an up sale. You then just pay a little extra for the difference. The company should be fine with it too, specially if it's the same brand PSU. Everything is still there, box, manual, bags, cables and all.
A bit annoying removing all the cables out, so ask a head of time on the phone or website contact us.
---
I know for the Nvidia GeForce RTX 3090 PSU requirements, you'll want a 750W power supply if you pair the card with a mainstream Core i5/i7 processor or Ryzen 5/7 CPU. That requirement jumps to 850W for Intel Core i9 and Ryzen i9 chips, with a peak of 1000W for Intel HEDT and AMD Threadripper platforms. The RTX 3080 should be similar or less than that.
The Intel 10700k CPU is a 10th Gen, but i7 right? So the 750W should still work. If it's not that easy to replace, I wouldn't worry about it to much. Just stress test it a bit and ensure it remains stable.
Strong and efficient 70A power stages on the main rails ensure the cleanest and most reliable power delivery. So check the +12V rail of your PSU and check is that 70 amps and higher? If so, then your 750W should be okay, thanks to it being a high-end one. It should also have 3 or more PCI-e power connectors, if it doesn't have that, you will need to replace it.
i have a very similar system to you (i7 8700k, 32gb of ram and 3 ssd's) i highly suggest you get a 850 watt psu for the 3090 as i just upgraded to it and with its power draw spikes i can somewhat barely get away with an 850 watt gold psu