Someone has the motherboard Asus Maximus Ranger VIII??

[CivCity]

I've built my new pc (every piece is new) but on my first try to power on the PC i get on this motherboard the QCode 00 error!!So no video signal, can't even make it to the bios!! Why is that?

[Beardface31]

Double check all your connections, most importantly the 24 pin mobo and 8 pin cpu power connection.

[CivCity]

引用自 Beardface：

Double check all your connections, most importantly the 24 pin mobo and 8 pin cpu power connection.

I've already did like 3-4 times, everything is in place and perfect! 24 & 8 pins connected, no missing pins or bent on the CPU...

[just.kamk /idle]

For these kind of problems it's usually recommended to list all of your hardware parts that are currently connected.

What it could be?
Hm... faulty PSU, mainboard, CPU, missing connection, short circuit somewhere, faulty BIOS.

[CivCity]

引用自 kamk：

For these kind of problems it's usually recommended to list all of your hardware parts that are currently connected.

What it could be?
Hm... faulty PSU, mainboard, CPU, missing connection, short circuit somewhere, faulty BIOS.

I have an I7-6700k CPU, 16 gb Kinston HyperXFury (2x8)DDR4 2133 mhz, Itek Desert 700W PSU, there are no bent pins or missing pins on the CPU or motherboard! Wich are the probabilities that a NEW CPU comes already broken, or motherboard? I've even tried with the motherboard outside the case on the "cover" of the MB! Still same error! tried Ram in different slots, tried with only 1 Ram, tried without Ram, tried installing new BIOS with "usb flashback"! Still "QCode 00" error!

[Bad 💀 Motha]

Have u taken the steps to reset the CMOS?

And did you try the onboard Intel GPU without PCIE GPU removed?

If still does not work after these, return the board.

Since u have taken the steps (as I would always suggest with any build) to try everything outside the case, can u please take and share some photos of the setup, so we can see the various power connections; etc.

[CivCity]

I've even done with integrated graphics! But nothing...Without GPU, without RAM, without any other component, only CPU and PSU! But the error remains. I've seen that the MB has a lot of leds to indicate errors (CPU LED,RAM LED and so on) but non of them are lit....so i don't know what is the problem If it was the CPU the CPU led should have been light up no?! Or something else!!

[Bad 💀 Motha]

Try the way u have it now, as described above (using onboard GPU)
Insert 1x RAM install DIMM slot #A1 and then when ready to power-on system, press the MemOK button on the Motherboard; located in the far-right-hand-corner.

When a board has onboard GPU and no RAM; the board should be spitting out a "no ram installed" type of error; or giving the corresponding audible beep codes for this, due to no installed RAM.

System must have a working GPU and at least 1x installed RAM to even boot.

[CivCity]

Ok done that! Pressed the MemOk, but nothing happens...after a few seconds i power on and still that F****** 00 Code appears!

[Bad 💀 Motha]

I would suggest return the board; either exchange or refund.
Read your place of purchase details or contact them for further support.

If the place of purchase is not an option, contact ASUS Support for your local country/region.