Nainstalovat Steam
přihlásit se
|
jazyk
简体中文 (Zjednodušená čínština)
繁體中文 (Tradiční čínština)
日本語 (Japonština)
한국어 (Korejština)
ไทย (Thajština)
български (Bulharština)
Dansk (Dánština)
Deutsch (Němčina)
English (Angličtina)
Español-España (Evropská španělština)
Español-Latinoamérica (Latin. španělština)
Ελληνικά (Řečtina)
Français (Francouzština)
Italiano (Italština)
Bahasa Indonesia (Indonéština)
Magyar (Maďarština)
Nederlands (Nizozemština)
Norsk (Norština)
Polski (Polština)
Português (Evropská portugalština)
Português-Brasil (Brazilská portugalština)
Română (Rumunština)
Русский (Ruština)
Suomi (Finština)
Svenska (Švédština)
Türkçe (Turečtina)
Tiếng Việt (Vietnamština)
Українська (Ukrajinština)
Nahlásit problém s překladem
swapping ram made the p4d alot snappier
DDR3 / DDR4 also known as double-data-rate ram there is a reason it's called this. Because the clock * 2 hence double data-rate. It also has the name "Double pumped RAM"
There is a similar varient to this in GDDR however this is known as Quadpumped RAM. Meaning the clock * 4.
Hope that helps.
gddr = graphics ddr
its not 4x, still 2x freq
the dedicated ram on gpus is clocked alot higher than current ddr4
You don't need to get defensive. Most unbuffered DDR2 667 was the older 1.8V spec which isn't compatible with the later 1.5V DDR2 800, 1066 and 1333 (they're keyed differently). Your hardware is probably still old, but 1333Mhz will perform significantly better, so if your board supports it, it would be a good idea to replace that older RAM with the best the board can support.
if this work with your M B
but this'll help
Friendly name Industry name Peak Transfer Rate
DDR2-533 PC2-4200 4266 MB/s
DDR2-667 PC2-5300 5333 MB/s
DDR2-800 PC2-6400 6400 MB/s
DDR2-1066 PC2-8500 8533 MB/s
ddr 2 1066 is pricey ..and quite hard to find even in the USA ..op is better off with a new system with DDR 4
\rather then try to upgrade an old DDR 2 main board ,,that may only support 4 gig @ 1066
and only certian dimms
depends what type of ddr 2 1066 it is for it to be pricey,
also it depends if this board can support this type of ram,
could be that all that would work would be ddr 2 800.