Cài đặt Steam
Đăng nhập
|
Ngôn ngữ
简体中文 (Hán giản thể)
繁體中文 (Hán phồn thể)
日本語 (Nhật)
한국어 (Hàn Quốc)
ไทย (Thái)
Български (Bungari)
Čeština (CH Séc)
Dansk (Đan Mạch)
Deutsch (Đức)
English (Anh)
Español - España (Tây Ban Nha - TBN)
Español - Latinoamérica (Tây Ban Nha cho Mỹ Latin)
Ελληνικά (Hy Lạp)
Français (Pháp)
Italiano (Ý)
Bahasa Indonesia (tiếng Indonesia)
Magyar (Hungary)
Nederlands (Hà Lan)
Norsk (Na Uy)
Polski (Ba Lan)
Português (Tiếng Bồ Đào Nha - BĐN)
Português - Brasil (Bồ Đào Nha - Brazil)
Română (Rumani)
Русский (Nga)
Suomi (Phần Lan)
Svenska (Thụy Điển)
Türkçe (Thổ Nhĩ Kỳ)
Українська (Ukraine)
Báo cáo lỗi dịch thuật
50-51 is not a high temp. Use MSI Afterburner and crank the fans up while temps are still low. Doesn't need to be 100%. 10% when temps 20 or 30 will atleast show you if the fans are working.
sagging is normal, a pcb can flex quite a bit before any damage is done to it
the only problem is the pci-e slot on the mobo, some will tear off the board with too mush stress for too long
if you have a support and its sagging a little its fine
pull the mobo, look at the pci-e slot
if the connector is lose from the board (any flex on it), its damaged and you need a new mobo or cpu/mobo/ram combo
Taking the motherboard out of the case would work too, but its more work.
But its the only way to test if the first pcie slot is damaged.
msi had the worst boards for am3/am3+
very weak mosfets for the vrm, with no thermal protection
most had weak vrm config with poor cooling
https://us.msi.com/Motherboard/970A-G43/Gallery#lg=1&slide=1
4+1 with 4 mosfets per phase no heatsink on them
Pretty much every GPU since RX 200 series and GTX 700 series does this.
There is simply no point in the fans running and wasting the bearing life span when the GPU is not hitting above 55-65*C