can i tape my mouse lens to the back of the circuitboard

[Weaponized Autism]

i have a lens rattle issue and this seems like a pretty easy fix, its the back of the circuitboard so no electronics or anything, would this be safe to do or not

[Carlsberg]

if you think it will work, try it with a little electrical tape. If it doesn't then get a new one, prices start at about $5 for a rattle free mouse, personally I would just replace it, mind you mine was terribly expensive at $34 from red dragon.

[Weaponized Autism]

Carlsberg eredeti hozzászólása:

if you think it will work, try it with a little electrical tape. If it doesn't then get a new one, prices start at about $5 for a rattle free mouse, personally I would just replace it, mind you mine was terribly expensive at $34 from red dragon.

its an mm710, the quality control is terrible on them, the last one i had was creaking everywhere and the clicks creaked so bad. i replaced it and this one is literally perfect except for the lens rattle. its just noise though, doesnt affect anything, so id rather not take another gamble

[Carlsberg]

Give the tape a shot, I probably would in your place. They use the same trick on laptops and tv's etc to insulate or hold parts in place without issue.

[Weaponized Autism]

Carlsberg eredeti hozzászólása:

Give the tape a shot, I probably would in your place. They use the same trick on laptops and tv's etc to insulate or hold parts in place without issue.

i ended up putting a thin layer of tape between the lens and bottom chassis as they make contact, lens rattle is gone