Rosewell 120mm fan screws wont fit case

[Vivukovi]

I bought a set of 120mm rosewell fans and the screws pn my ms-1 thermaltake commander case screw holes are too small for them. No i cant force it in my case and i know that the fans become thteaded with the screws. About to just buy a set that wont screw me over. Also does the ryzen 5 have a plastic film on it?

[Vivukovi]

Originalmente postado por Bad_Motha:

You mean Paste? That should only be on the Heatsink side when dealing with new parts, if you're referring to pre-applied kind. If neither CPU or Heatsink have paste, apply paste to the CPU, no more then a pea-sized.

On your Case, popoff the front cover and install front case fan(s) using the long screws provided with the Case.

I see the long ones but theres only 4 and id like 2 fans in the front since i cant put any up top. Also im aware of preapplied paste. Im basically atressing out thinking there was film somewhere on the processor but i didnt see any. Plus when i put the coolet on the cpu it basically got sucked onto it.

[Bad 💀 Motha]

Well 4x of those 8 screws should already be there from a pre-installed front fan.

If you do install just one fan, it's fine, make it a good one, like Corsair AF or SP high-performance series. and put it at the top-most mount holes. Shouldn't really have a need to put anything at the bottom area, unless you have a ton of Drives installed.

[Vivukovi]

Originalmente postado por Bad_Motha:

Well 4x of those 8 screws should already be there from a pre-installed front fan.

If you do install just one fan, it's fine, make it a good one, like Corsair AF or SP high-performance series. and put it at the top-most mount holes. Shouldn't really have a need to put anything at the bottom area, unless you have a ton of Drives installed.

I cant install any fans. Even if i buy more it wont change anything. Ill have the same problem.

[Bad 💀 Motha]

You can get replacement screws at the hardware store; not sure why you don't have them, all screws you would need came with your Case.