Nainstalovat Steam
přihlásit se
|
jazyk
简体中文 (Zjednodušená čínština)
繁體中文 (Tradiční čínština)
日本語 (Japonština)
한국어 (Korejština)
ไทย (Thajština)
български (Bulharština)
Dansk (Dánština)
Deutsch (Němčina)
English (Angličtina)
Español-España (Evropská španělština)
Español-Latinoamérica (Latin. španělština)
Ελληνικά (Řečtina)
Français (Francouzština)
Italiano (Italština)
Bahasa Indonesia (Indonéština)
Magyar (Maďarština)
Nederlands (Nizozemština)
Norsk (Norština)
Polski (Polština)
Português (Evropská portugalština)
Português-Brasil (Brazilská portugalština)
Română (Rumunština)
Русский (Ruština)
Suomi (Finština)
Svenska (Švédština)
Türkçe (Turečtina)
Tiếng Việt (Vietnamština)
Українська (Ukrajinština)
Nahlásit problém s překladem
2 : puting a hanging brazier close the floor , you can do this with with 1m poles over the floor
Once I could build with stone, I pick-axed the column of earth and replaced it with a shaft of 2 x 1 stone blocks. I placed the first two side by side to form a 2 x 2 base then rotated the next 2-block tier 90 degrees. I capped the shaft with a 2 x 2 stone floor piece. The cap protrudes above the surrounding wood second floor by 20-25 centimeters. Not perfect, I know, but it keeps me out of the fire.
I have seen posts where fastidious vikings build their fires on the ground surrounded by floor tiles and then snap a floor tile into place in the fire. They prefer not to look at the ground.
If one carefully aligned the top of an earth column with the surrounding floor tiles perhaps one could do the same.
An adventurous viking might then pick-axe the earth column in hopes that the fire and its associated floor tile would remain in place.
Then you can pick to excavate all around it. As you dig around, make sure to use vertical wooden beams to support the floorboard. As long as you keep the floorboard supported while excavating, the campfire will remain levitated.
A quicker way is to get a bunch of stone and raise ground with the hoe. Raise ground directly below your feet for as high as you wish to. Drop the campfire on top of it, and then proceed with the floorboard beneath and supporting beams.
After either of these methods you can even remove the floorboard and the campfire will remain levitating as long as there are those supporting vertical beams in place, or something else that's load bearing. Try experimenting with it. Any piece not dark red on load bearing can support the campfire after removing the floorboard beneath it.
A) Raise ground to as high as you can and build a house araund it (just a pillar)
B) Use stone (you can start with iron and then move to stone for even greater height)
C) You can use iron pillars and place fireplace on them BUT!!!!! you will not get a reseted buff (still good for visuals)
Example:
https://i.ibb.co/gjXR9XJ/trhjewkjwkj23232323.png
https://i.ibb.co/wNwmTNs/trhjewkjwkj23232324.png
P.s. dont ask me how much iron bars i used..ugh... (a whole largest boat full of iron)
But if you just need some light, torches, mushums lights, sufling heads, ice resistance potions always work well.
You don't need the stone floor. I built one on two stone pillars that's two pillars high.
https://steamcommunity.com/sharedfiles/filedetails/?id=2660552367
https://steamcommunity.com/sharedfiles/filedetails/?id=2660552470
https://steamcommunity.com/sharedfiles/filedetails/?id=2660552649
That said the best solution is to build on top of a large rock and use the top of the rock for the fire base.
https://steamcommunity.com/sharedfiles/filedetails/?id=2660632173
https://steamcommunity.com/sharedfiles/filedetails/?id=2660632375
https://steamcommunity.com/sharedfiles/filedetails/?id=2660632610
Yeah, the kiln smoke goes thru the camp fire, but it temporarily puts out the campfire, only when the kiln is running. I usually have a couple of kilns, so it's not noticed.