throttle problem

[aBq7io9]

Logitech g29 set
when i use full throttle, throttle strip seems to jumps
maybe someone had such a problem
I will be grateful for your kind advice

[Roddy]

sounds like maybe the sensor is dirty?
maybe try this;
https://www.youtube.com/watch?v=xd5gDZ5AWwQ

[Ulanthorn]

The problem is potentiometers that tend to wear off very quick. If replacement is due look for more modern pedals that use hall sensors instead of Potentiometers.

[grizta30]

As above its a potentiometer issue, that being said it most likely just needs a clean, get a can of compressed air and try that first.

[aBq7io9]

thanks for the advice, I'll try to clean the potentiometer

[medioman-ita]

The potentiometer will either be dusty or start to malfunction. You can calibrate the minimum and maximum of the pedal from the control panel or use a programme called DIView

[EF_Neo1st]

Reduce max throttle range (use max throttle deadzone) and increase min throttle range (use min throttle deadzone) until where you dont have this problem (and try cleaning yuor potenciometers).

[teściu00]

I have a different solutions for you to check. First of all make sure that the problem is present if you are going on the long straight with TC set to 1 or even zero. If yes, than it's not a TC problem. Next step, make sure that none of the cables are not crushed or squized in any way. I had similar problem and it turned out that when i made sure that cables are not squized the problem went away. But if none of this helps i gues the potentiometer solution will be a good thing to try.

[aBq7io9]

The problem disappeared after a complete cleaning of the potentiometer. Thank you all for your attention and advice.