The Elder Scrolls V: Skyrim

The Elder Scrolls V: Skyrim

查看统计:
Volkan 2015 年 6 月 16 日 下午 3:27
boethiah's calling HELP
Hi everyone, I have problem in boethiah's calling quest. I suppose to kill everyone in the cave. Altough I killed everyone, my quest line is stuck at "Slay everyone at Knifepoint Ridge stealthly". It is probably because I cleaned the mine before to kill bandit leader. I checked for the solutions but couldn't find any. I appreaciate your help! Thank you!
最后由 Volkan 编辑于; 2015 年 6 月 16 日 下午 3:39
< >
正在显示第 1 - 4 条,共 4 条留言
Dr. Stefen Lowbert 2015 年 6 月 16 日 下午 3:39 
Hmm, you may have to wait for the cell to respawn. Usually only a few in-game days. However I never did this quest so... You can probably also console command to finish the quest if it ends up never respawning as a last resort. But yeah, you'll probably have to wait for the cell to respawn. There is a console command that allows you to refresh the current cell. It's this:

~" resetinterior <cellid> "

The Cell ID is this: KnifepointRidge01

If you recently just killed everyone before the quest, you'll have to do an additional console command which is ~" pcb " but I recommend doing this only if it was recent (if the bodies are gone you'll be okay, if not you'll have to use this command.)

Hope that helps. Remember to make a good save before doing any of this however, never know what may happen with console commands if you need to resort to them. I have done this before and have had no issue btw, but always best to be safe.
--------------------------------------------------------------------------
EDIT: here's a more detailed explanation of the resetinterior command, directly from the UESPWiki.

"This command will reset an entire dungeon or location to default, including monsters, traps, chests and loot. E.g., ResetInterior Stillborncave01 or ResetInterior 00015206 would reset the dungeon Stillborn Cave to default; all monsters, traps, and loot would be respawned. If you reset a cell you have just been to, you'll need to use pcb command (purge cell buffer) as well, or the game will reload the buffered version of the cell, with all the modifications you've made to it. Both editorID and formID are acceptable in this command. Using this command in player homes appears to reset the furnishings without clearing the contents of initially empty containers, however, all weapon racks and cases will be empty and mannequins will need to have their inventories removed and replaced. (viz., the bedroom chest)"
最后由 Dr. Stefen Lowbert 编辑于; 2015 年 6 月 16 日 下午 3:42
Volkan 2015 年 6 月 16 日 下午 3:58 
Thanks a lot but it didn't work again, I guess, I need a console command to finish quest. Altough I wrote the command, knifepoint ridge is still seen as "cleared" on the map. It might be the problem, I am not sure.
OutsidR 2015 年 6 月 16 日 下午 5:55 
In my sequence, I was supposed to kill some one in front of her alter. Needless to say, I just didn't complete it yet.
Antares 2015 年 6 月 16 日 下午 7:28 
yeah that one gave me a bit of a dillema too. As I most definitely would not kill of one of my hot wiveS, Or any of the loyal followers I had been relying in so much throughout the game, I Remembered that there was a cat guy that became a follower after finding the moon amulet for him. So I went and used him because I wasn't attached to him...No remorse...LOL.
Funny thing is that you can point a red dot on the altar stone to make him go grab it...
True Story!
< >
正在显示第 1 - 4 条,共 4 条留言
每页显示数: 1530 50

发帖日期: 2015 年 6 月 16 日 下午 3:27
回复数: 4