Found a fix for LODs failing to unload

[Duck, The Police]

in your Skyrim.ini (located at "Documents\My Games\Skyrim") deleting these lines under [MapMenu]

uLockedObjectMapLOD=32
uLockedTerrainLOD=32

6 years of searching obscure forums finally found a fix. Me and another that were having such issues tested it for the last few days and haven't had the problem resurface after doing this. Would be nice to know if it doesn't work for everyone.

[Kplus8]

mirroring sergiominium, so glad I caught this right before thinking I would have to do a complete step-by-step reinstall.
Glad to have found an answer and not a "found out, nevermind" forum thread.

[Tobias]

I have also never seen these lines in any of my Skyrim.ini(s). Where the hell are you getting these lines? They sure as hell aren't in Skyrim.ini, SkyrimPref.ini or any other .ini files.

[GneepGnarp]

I know this thread is old but I just loaded an old save and it fixed the issue

[Khanne]

引用自 ♥✿Rose✿♥：

I know this thread is old but I just loaded an old save and it fixed the issue

Temporary fix because it will happen again

["The Fungus"]

thank you for this post, whole lot of confusing ♥♥♥♥♥♥♥♥ you gotta search through when you get this bug but you saved me from that :)

[Moonlight]

thanks to this post, i could track down where the bug was coming (at least in my mod list), A Clear Map Of Skyrim And Other Worlds has an ini that sets both those values to 32 for dyndolod 3 generation, if you run dyndolod it works fine but in bruma it bug it out badly because by default it dosent generate LOD. Generating LOD or changing/deleting those values fixes the problem. if you dont have dyndolod generation it also bug out all the time in vanilla skyrim

[Samy]

Oh thanks i was almost sure my problem came when i installed ACMOS but not sure. Now i will make my test. The problem is you have to generate texture lod which is called "terrain lod" when you convert it in 4*4 by ACMOS path only. Then you make one more LODGEN for the textures for classic terrain and then you re doing the usual TEXTGEN + DYNDO. But i think STEP options are not so good or there is a bug inside. Even with the use of DYNDOLOD i have hard textures bug.

There is two tips if you want to "cancel" temporay this bug and want to use ACMOS anymore :
quit the game and restart it, but it can last 1 hour 2 hours or less it depends. Second is the best : enter inside an other are than skyrim then open the console and type PCB . It solves it for a while.

At the end i m not sure but will make some tries with ACMOS to see if it comes from it. Since i use it i have bad bugs

[Samy]

Ok so it works perfectly and i managed to solve my problem by following rules from ACMOS and clear map precisely
1)First you install clear map
2) you launch lodgen with https://stepmodifications.org/wiki/SkyrimSE:2.3#LOD_Setup
Then you install acmos generator
3) you convert lodgen with acmos and choose path only
4) you use your lodgen file and you put it in an empty mod as explained by step team
5) you active your mod then you launch text gen
6) MOST IMPORTANT , you use DYNDOLOD instruction precisely of the a clear map mod page or you will have lod bugs
7) enjoy nice LOD and beautiful map