the Controls are extremely difficult to work with and the throttle.

[MCFuryan]

I was having a terrible time trying to find something I could work with to I can get better at this game but even with these settings being the lowest i could go it's still difficult.

The Throttle is my worst problem when not trying wheelie bike out into a crash but still do even with lowest settings i could possibly work with unfortunately.

My Best settings I could come up with and it took me many hours! after purchasing this game.

Under (Controls) For Xbox one controller

(Lean) Control <>
(Rider L/R Lean) >< to help with leaning the Corners on your Right Thumb Stick.
(Direct Lean) 27% If I set this any lower then 25% The bikes Steering will stick too long in the direction i steer to before it will turn back to the middle and will cause me to crash.

Under (Advanced) On your Right these settings are my following setup.

(Lean) Settings: This is best i could come up with when trying to make those turns but can't even go fast enough but maybe with practice with these settings I might for now.

Dead Zone: 5%
Linearity: 0%
no check in Smooth
Gain: 66.7% that's lowest i could go!

(Rider L/R Lean) Settings.

Dead zone: 0%
Linearity: 100%
No Check in Smooth

(Throttle) Settings

With out wheeling so badly But I still was vary badly even on a 250 bike!.
Dead Zone: 0%
Linearity: 0%
No Check in Smooth
Gain: 100% and that's lowest I could go and still wheeling the bike out into a crash badly!.

I can't even down shift my bike to stop the wheelie from flipping me, watch out if you give gas going down any slopes because you will even wheelie down them.

Don't throttle off a jump because no way can we balance bike while in the air to lower that front wheel and you will bounce then flip the bike into a crash.

Bike feels like your a vary light balloon trying to not bounce or give too much throttle or lean too far and if i change too many times my controls and throttle i have to exit game and come back in to fix it but have to make sure to set Linearity back at default 100% before exiting, only happens if i change my rider F/B lean then Linearity: at 0% then the trouble begins, have to exit to fix.